Specifications

Chapter 9 – Call Control Commands
Multi-Tech Systems, Inc. CDMA C1 AT Commands Reference Guide 43
48 Call rejected because of redirection or handoff.
49 Access is blocked by base station for all mobiles. (KDDI specific).
50 OTASP SPC Error indication.
202 Call origination on IP Failed.
401 Origination throttled.
402 Unknown Error.
To receive +WORG, +WCNT, and +WEND unsolicited responses, set the AT+WUSLMSK command
to enable the responses.
Call Originated +WORG
Description: This response indicates that an attempt to establish a voice call has occurred.
Response
Syntax: +WORG: <number>
Command
Possible Responses
ATD18005551212;
OK
+WORG:18005551212
+WCNT:3
OK
Notes:
<number> is the dialing string sent to the base station. You may see extra numbers before the
intended dialing string; this is a result of pre-pended numbers or other call options.
<number> could also be the NULL string if there is no user supplied origination address as in the
case o SMS.
If <number> is not present, check the +WUSLMSK settings.
CPHS Command +CPHS
Description: This command is used to activate, deactivate or interrogate a CPHS feature (e.g., Voice Mail
Indicator). When performing an interrogation (mode = 2), the selected <FctId> CPHS feature is
automatically enabled (status = 1).
Note: This command will return +CME ERROR: 3 if the CPHS feature is disabled.
Syntax: AT+CPHS=<Mode>,<FctId>
Command
Possible Responses
AT+CPHS=<Mode>,<FctId>
OK
AT+CPHS?
+CPHS: <Status>,<FctId1><CR<LF>
OK
AT+CPHS=?
Note: display the range of values
+CPHS: (0-2),(1-1)
OK
Values: <Mode>
0 Deactivate a CPHS feature
1 Activate a CPHS feature
2 Interrogate a CPHS status
<FctId>
1 Voice Mail Indicator