Specifications

Chapter 9 – Call Control Commands
42 Multi-Tech Systems, Inc. CDMA C1 AT Commands Reference Guide
Call Ended +WEND
Description: This response indicates that a voice call or attempt to establish a voice call has ended.
Response
Syntax: +WEND: <reason>
Command
Possible Responses
ATD18005551212;
ATH
OK
+WORG:18005551212
+WCNT:3
OK
+WEND:29
Note: Call Ended with a normal release
ATD18005551212;
OK
+WORG:18005551212
+WEND:22
Note: Call failed because the signal faded.
Values: <reason>
0 Phone is offline
20 Phone is CDMA locked
21 Phone has no service
22 Call Faded/Dropped
23 Received Intercept from Base Station
24 Received Reorder from Base Station
25 Received a Release from Base Station (This is a normal call termination).
26 Service Option rejected by Base Station
27 Received Incoming Call
28 Received an alert stop from Base Station
29 Software ended the call (Normal release).
30 Received End Activation – OTASP calls only.
31 Internal Software aborted the origination/call.
32 Maximum Access probes exhausted (The modem failed to contact the Base Station)
33 Persistence test failure
34 RUIM not present
35 Origination already in progress
36 General Access Failure
37 Received retry order (IS-2000 only).
38 Concurrent service is not supported by base station.
39 No response received from base station.
40 Call rejected by the base station.
41 Concurrent services requested were not compatible.
42 Access is blocked by base station. (Release A only).
43 Traffic channel already available.
44 Call is ended due to Emergency call is flashed over this call.
45 CM is ending a GPS call in favor of a user call. (GPS_ONE only).
46 CM is ending a SMS call in favor of a user call.
47 CM is ending a DATA call in favor of an emergency call.