Specifications
Table Of Contents
- Chapter 1 – Introduction
- Chapter 2 – AT Commands Overview
- Chapter 3 - General Commands
- Chapter 4 – Identification Commands
- Chapter 5 – Query Commands
- Chapter 6 – Global Configuration Commands
- Chapter 7 – Status Commands
- Chapter 8 – Communication Commands
- Fixed DTE Rate +IPR
- DTE-DCE Local Flow Control +IFC
- Set DCD Signal &C
- Set DTR Signal &D
- Set DSR Signal &S
- V.42bis Data Compression +DS
- V.42bis Data Compression Report +DR
- Hang-Up 1x Data Command +WCHD
- Automatic Answer S0
- Line Termination Character S3
- Response Formatting Character S4
- Command Edit Character S5
- Connection Completion Timeout S7
- Carrier Detect Threshold S9
- Automatic Disconnect Delay S10
- DTMF Duration and Spacing S11
- Chapter 9 – Call Control Commands
- Dial Command D
- Hang-Up Command H
- Answer a Call A
- Calling Line Identification Presentation +CLIP
- Call Waiting Indication +CCWA
- Incoming Call +RING
- Set Voice Privacy Level +WPRV
- Emergency Mode +WSOS
- Call Answered +WANS
- Call Connected +WCNT
- Call Ended +WEND
- Call Originated +WORG
- CPHS Command +CPHS
- Voice Mail Indicator +WVMI
- List Current Call State +CLCC
- Call Forwarding +CCFC
- Send Flash to Base Station +WFSH
- Send DTMF Tones +VTS
- Chapter 10 – Network Service Commands
- Serving System +CSS
- Set Rm Interface Protocol +CRM
- Signal Quality +CSQ
- Network Registration & Roaming +CREG
- Set More Preferred Rescans +WTBMPRS
- Band Preference +WBND
- Service Indication +WSRV
- Roam Preference +WRMP
- Default Cell Band +WDCB
- Roaming Indication +WROM
- Enhanced Roaming Indication +WERI
- Cell Environment and RxLev Indication +CCED
- Chapter 11 – Provisioning Control Commands
- Chapter 12 – OTASP / OTAPA Indications
- Chapter 13 – OMA / DM Control Commands
- Chapter 14 – Short Message Service Control Commands
- Send Message +CMGS
- Read Message +CMGR
- List Message +CMGL
- Delete Message +CMGD
- Preferred Message Storage +CPMS
- Set SMS Compose Language and Encoding +WSCL
- New Message Indication +CNMI
- Incoming Message Directly Displayed +CMT
- Incoming Message Stored in Memory +CMTI
- SMS Status Report Indication Directly Displayed +CDS
- SMS Message Storage Full +WMGF
- Chapter 15 – Audio Commands
- Audio Subsystem Overview
- Speaker & Microphone Selection +SPEAKER
- Microphone Gain Enable +MGE
- Microphone Gain +VGT
- Speaker Gain Control +VGR
- Digital Gain Transmit +WDGT
- Digital Gain Receive +WDGR
- Side Tone Modification +SIDET
- Echo Cancellation +ECHO
- Loudspeaker Volume Level +CLVL
- Initialize Voice Parameters +VIP
- Audio Loopback &T
- Chapter 16 – Data Commands
- Chapter 17 – TCP App AT Commands (For Non-UIP Builds)
- Configure TCP/IP +WIPCFG
- Bearer Configuration +WIPBR
- Bearer Status +WIPBR
- Service Creation +WIPCREATE
- Service Status Unsolicited Response 1 +WIPREADY
- Service Status Unsolicited Response 2 +WIPACCEPT
- Service Status Unsolicited Response 3 +WIPERROR
- Last Socket Error Query +WIPERR
- Socket Data Exchange +WIPDATA
- TCP/IP Service Option Handling +WIPOPT
- Closing a Service +WIPCLOSE
- Close Service Status +WIPPEERCLOSE
- Enable Relay Mode for SIP Dial-Up +WRLY
- Chapter 18 – Sleep Commands (Not for UIP)
- Chapter 19 – Host Application Scenarios
- Chapter 20 – Effects of AT&W, ATZ, and AT&F
- Chapter 21 – CDMA Terminology and Acronyms
- Index

Chapter 21 – CDMA Terminology and Acronyms
128 Multi-Tech Systems, Inc. CDMA C1 AT Commands Reference Guide
F
Fixed DTE Rate +IPR ....................................................... 28
Flash Indication for +WFSH ............................................. 47
G
General Indicator +WIND ............................................... 22
General Indicator Unsolicited Message +WIND ............. 23
H
H Hang Up ...................................................................... 36
Hang Up H ..................................................................... 36
Hang-Up 1x Data +WCHD .............................................. 31
Hardware Version +WHWV ........................................... 17
I
IMSI Download OK +WOTI ............................................. 67
Incoming Call +RING ...................................................... 38
Incoming Message Displayed +CMT .............................. 82
Initial Programming Required +WOT0 ........................... 65
L
Last Socket Error Query +WIPERR ................................ 105
Line Termination Character S3....................................... 32
List Message +CMGL ...................................................... 77
Local Flow Control +IFC .................................................. 28
Location of Stored Message +CMTI ............................... 82
Loudspeaker Volume Level +CLVL ................................. 92
M
Manufacturer Identification +CGMI............................... 18
MDM Download OK +WOTM ......................................... 67
Microphone Gain +VGT .................................................. 87
Microphone Gain Enable +MGE ..................................... 86
MIP Selection $QCMIPP ................................................. 96
N
NAM Download OK +WOTN .......................................... 66
Network Registration & Roaming Status +CREG ............ 51
Network Registration & Roaming Status Unsolicited
Response +CREG ......................................................... 52
New Message Indication +CNMI .................................... 80
Non-Volatile Memory Unsolicited Message +WNVM .... 27
O
OTAPA ............................................................................. 65
OTASP ............................................................................. 65
P
Phone Activity Status +CPAS .......................................... 26
Primary CDMA Channels +WPCC ................................... 63
PRL Download OK +WOTP ............................................. 67
Programming in Progress +WOT1 .................................. 65
Programming Successful +WOT2 ................................... 65
Programming Unsuccessful +WOT3 .............................. 66
Q
Query Scan Sleep State +WSPS .................................... 111
Quick Net Connect $QCQNC .......................................... 95
R
Read CDMA Network Time +WNETTIMEGET............... 112
Read Message +CMGR ................................................... 76
Report Mobile Equipment Errors +CMEE ...................... 24
Request Model ID (Frequency Bands +CGMM .............. 18
Request PRI Version information +WPRI ...................... 16
Request Product Serial Number +WMSN ...................... 18
Request Revision Identification +CGMR ........................ 17
Reset to Default Configuration Z0 ................................. 21
Response Formatting Character S4 ............................... 32
Restore Factory Settings &F .......................................... 21
Return Profile Information $QCMIPGETP ...................... 97
Roam Preference +WRMP ............................................. 54
Roaming Status +WROM ............................................... 55
R-SCH IP Selection $QCMIP............................................ 96
S
S0 Automatic Answer..................................................... 32
S10 Automatic Disconnect Delay ................................... 33
S11 DTMF Duration and Spacing ................................... 34
S3 Line Termination Character ...................................... 32
S4 Response Formatting Character ............................... 32
S5 Command Edit Character .......................................... 33
S7 Connection Completion Timeout .............................. 33
S9 Carrier Detect Threshold ........................................... 33
Save Configuration &W ................................................. 21
Send DTMF Tones +VTS ................................................. 47
Send Flash to Base Station +WFSH ................................ 46
Send Message +CMGS ................................................... 75
Service Creation +WIPCREATE ..................................... 102
Service Indication +WSRV .............................................. 53
Service Programming Code +WSPC ............................... 60
Service Status Unsolicited Response 1 +WIPREADY .... 104
Service Status Unsolicited Response 2 +WIPACCEPT .. 104
Service Status Unsolicited Response 3 +WIPERROR .... 104
Serving System +CSS ...................................................... 49
Set CDMA Network Time Format +WNETTIMEFMT .... 111










