Owner`s manual

MR4800E Owner’s Manual

setsendtrap

Parameters: on, off

Description: Configure the MR4800E controller card to send traps or not. This command can be

used to disable the sending of traps from a controller card to a SNMP manager or

MultiModemManager console.

Security: Supervisor

Example:

[0] A:\ # getsendtrap

The sending of traps is enabled.

[1] A:\ # setsendtrap off

The sending of traps has been successfully disabled.

[2] A:\ # getsendtrap

The sending of traps is disabled.

setsubnet

Parameters:

IP Address Mask

Description: Configure the subnet mask. The setsubnet command allows you to change the subnet

mask to the IP Address parameter. See

se.

Security: Supervisor

Example:

[0] A:\ # setsubnet 255.255.255.0

Subnet mask 255.255.255.0 stored

[1] A:\ #

settrap

Parameters:

IP Address

Description: Configure the trap address. The settrap command allows you to change the default

trap IP Address to the IP Address parameter. This IP is where fault/status traps are sent.

See

se.

Security: Supervisor

Limitations: Only one default trap address may be set at one time.

Example:

[0] A:\ # settrap 199.199.199.6

Trap IP Address 199.199.199.6 stored

[1] A:\ #