Owner`s manual

CC1600-Series Owner's Manual

Power Supply Installation

The CC1600-series modem rack is configured with either a

single power supply or two (hot-swappable, redundant) power

supplies. A single power supply can maintain a full

complement of 16 modems or DSUs. To install a power

supply, perform the following procedure.

1. Unpack the power supply and check for visible shipping

damage. If damage is observed, do not install the power

supply; contact Multi-Tech's Technical Support for advice

(refer to Chapter 3).

Power Supply

Cover

Figure 2-3. Power Supply Installation

2. Using a Phillips screwdriver, loosen the two power supply

cover mounting screws and remove the cover from the slot

where you intend to install the power supply.

3. Slide the power supply into the two mating card guides

and firmly seat the power supply connectors into the

backplane connectors.