Owner`s manual

Chapter 2 - Installation

Modem

Component

Side

Rack

Door

Slot 1

Figure 2-1. Modem Installation

9. Firmly seat the modem card into the backplane connector.

10. Repeat steps 7 through 9 for the remaining modems.

11. Connect an RS232C cable to the DB25 connector (25-pin

female connector) on the backplane of the rack. Start by

connecting the RS232C cable to the right-most channel

(slot 1) as viewed from the back of the rack.

Note: Any cables connected to the computer should be

shielded to reduce radio frequency interference. Keep

track of which computer channel belongs to which modem

in the rack. Most computer interface buses are grouped in

sixteens, which enables you to match modem and

computer channel numbers.