Owner`s manual

CC1600-Series Owner's Manual

and TN (Telecommunications Network) circuits to TN

circuits.

Installation

Perform the following procedure to install the CC1600-series

modem rack and install up to 16 modems in the rack.

1. Unpack the rack and check all items against the shipping

list to ensure that you have received the correct items.

Rack Components

A. Rack

B. Power Cord

C. Owner's Manual

2. Inspect the rack for visible shipping damage. If damage is

observed, do not power-on the rack; contact Multi-Tech's

Technical Support for advice (refer to Chapter 3).

3. If no damage is observed, mount the rack in a standard

19-inch wide rack enclosure. Mounting hardware should

be provided with the rack enclosure.

4. If power supply is not installed in rack, refer to the

following section for power supply installation. If the power

supply is already installed, proceed to step 5.

5. Open the rack front door.

6. Unpack the modems to be installed in the rack.

7. Refer to the RackMounted Modem Owner's Manual for the

switch settings and parameters which pertain to your

application (dial-up/leased-line).

8. Slide a modem into one of the 16 available slots. The

component side of the card should be to the right as in

Figure 2-1. The modem's gold edge connector will mate

with the rack's backplane. The edge connector is offset

vertically so the modem cannot be inserted upside down.