Owner`s manual

11
Chapter 2 - Installation
Safety Recommendations
The following safety recommendations should be observed
when installing Multi-Tech CC1600-series modem racks.
• Ensure proper installation of the CC1600-series modem
racks in a closed or multi-unit enclosure by following the
recommended installation as defined by the enclosure
manufacturer. Do not place the CC1600-series modem
rack directly on top of other equipment or place other
equipment directly on top of the CC1600-series rack.
• If installing the CC1600-series modem rack in a closed or
multi-unit enclosure, ensure adequate airflow within the
rack so that the maximum recommended ambient
temperature is not exceeded.
• Ensure that the CC1600-series modem rack is properly
connected to earth ground via a grounded power cord. In
the event that a power strip is used, ensure that the power
strip provides adequate grounding of the attached
equipment.
• Ensure that the mains supply circuit is capable of handling
the load of the CC1600. Refer to the power label on the
equipment for load requirements.
• Maximum recommended ambient temperature for the
CC1600 is 50° C (120° F).
• This equipment should be installed only by properly
qualified service personnel.
• Only connect like circuits. In other words, connect SELV
(Secondary Extra Low Voltage) circuits to SELV circuits