User Manual

- Put the six jumper connector to the required positions.
- Plug JR connector (part of ESC) to the specified socket on Prog-Card (orange wire-signal, brown wire-cathode(-), red
wire-anode(+)).
- Connect the motor to the ESC and connect the power to the ESC(Take care safety).
- For OPTO ESC without BEC, connect the 4.8V of battery pack to the Prog-card.
- 1 “beep” will be heard in a second, which means your setting has been saved(“beep” will not be heard if there is no change of
parameter).
- Disconnect the power pack (For OPTO ESC , disconnect the Prog-Card to it’s battery pack ).
MOTOR
BATTERY
MOTOR
BATTERY
BATTERY
4-6V
Diagram for option parameter assistant by Prog Card
Operation - For ESC with Prog Card
Option parameter assistant by Prog-Card
Brake —Off: Brake is switched off.
Brake — Medium: The brake is on and its middle effect is fit for gear drivers
Brake — Hard: The intensity of brake becomes much higher
Timing — Automatic: automatic timing (for all types of motors)
Timing — High: hard timing（recommended for more than 10 poles motors and outrunners motors）
Timing — Low: soft timing（recommended for motors of 2-8 poles motors and inrunner motors）
Note: When the timing mode is saved, please adjust the motor on the ground before the flight.
Brake Type
Timing Mode
Acceleration — High: fast acceleration or deceleration of motor
Acceleration — Medium: acceleration or deceleration in middle speed
Acceleration — Soft: slow acceleration or deceleration
Acceleration
Battery Type — Ni-XX: Ni-Cd & Ni-MH
Battery Type — Li-XX: Li-ion & Li-polymer
Battery Type — Li-Fe
Cut-off Voltage — High: high cut-off voltage of battery type you selected
Cut-off Voltage — Medium: middle cut-off voltage of battery type you selected
Cut-off Voltage — Low: low cut-off voltage of battery type you selected
Battery type
Cut off Voltage mode
High
Medium
Low
Ni-Cd & Ni-Mh
0.9V
0.8V
0.6V
Li-Fe
2.8V
2.5V
2.2V
Li-ion&
Li-polymer
3.2V
3.0V
2.8V
Cut-off Voltage — Cut-off Voltage of ESC
The direction of rotation of motor can be achieved by exchanging any two of three output wires from ESC. If you don’t want to
change the wire between the ESC and motor, you can set the ESC to change the direction of rotation. If the direction of rotation is
needed, when the jumper connector is put to the position, the ESC only receives the change of direction of motor rotation but the
other changes from the Prog-Card. Continuously “beep” will be heared until the power pack will be cut off. When the direction of
rotation is changed, please put the jumper connector to the former position.
Direction of motor rotation