Operation and Parts Manual MODEL ss233 submersible pump Revision #2 (03/22/10) To find the latest revision of this publication, visit our website at: www.multiquip.com THIS MANUAL MUST ACCOMPANY THE EQUIPMENT AT ALL TIMES.
Table of Contents SS233 Submersible Pump Table Of Contents..................................................... 2 Parts Ordering Procedures....................................... 3 Safety Information................................................. 4-7 Specifications........................................................... 8 General Information.................................................. 9 Components........................................................... 10 Operation...........................
www.multiquip.com Parts Ordering Procedures Ordering parts has never been easier! Choose from three easy options: order via internet (dealers only): best deal! Effective: January 1st, 2006 If you have an MQ Account, to obtain a Username and Password, E-mail us at: parts@multiquip. com. Order parts on-line using Multiquip’s SmartEquip website! ■ View Parts Diagrams ■ Order Parts ■ Print Specification Information To obtain an MQ Account, contact your District Sales Manager for more information.
Safety Information Do not operate or service the equipment before reading the entire manual. Safety precautions should be followed at all times when operating this equipment. Failure to read and understand the safety messages and operating instructions could result in injury to yourself and others. Potential hazards associated with the operation of this equipment will be referenced with hazard symbols which may appear throughout this manual in conjunction with safety messages.
Safety Information general SaFeTY CauTion never operate this equipment without proper protective clothing, shatterproof glasses, respiratory protection, hearing protection, steel-toed boots and other protective devices required by the job or city and state regulations. Avoid wearing jewelry or loose fitting clothes that may snag on the controls or moving parts as this can cause serious injury. never operate this equipment when not feeling well due to fatigue, illness or when under medication.
Safety Information pump SaFeTY danger never operate the equipment in an explosive atmosphere or near combustible materials. An explosion or fire could result causing severe bodily harm or even death. never use pump for swimming pool dewatering applications. This can result in electrical shock or electrocution. Warning Accidental starting can cause severe injury or death. alWaYS place the ON/OFF switch in the OFF position. do noT place hands or fingers inside pump when pump is running.
Safety Information power Cord/Cable Safety danger never let power cords or cables lay in water. never use damaged or worn cables or cords. Inspect for cuts in the insulation. never grab or touch a live power cord or cable with wet hands. The possibility exists of electrical shock, electrocution or death. Make sure power cables are securely connected to the motor's output receptacles. Incorrect connections may cause electrical shock and damage to the motor.
specifications Table 1. Specifications Model SS233 Type Submersible Pump Impeller Plastic Suction & Discharge Size 2.00 in. (50.8 mm) 60 gallons/minute Maximum Pumping Capacity (227 liters/minute) 5 ft (1.5 meters) 3,318 gallons/hr (12,560 liters/hr) 10 ft (3.0 meters) 2,808 gallons/hr (10,629 liters/hr) Discharge Height 15 ft (4.5 meters) 1,482 gallons/hr (8,358 liters/hr) Above Pumping Level 20 ft (6.0 meters) 1,482 gallons/hr (5,610 liters/hr) 30 ft (9.1 meters) 300 gallons/hr (1,136 liters/hr) Power 0.
general information Introduction The SS233 submersible pump is designed to pump water and is used for the draining (de-watering) of flooded rooms, drains and fill tanks, power fountains and waterfalls swimming pool covers, and flat roofs. A plastic impeller is attached to the output shaft of a 1/2 HP electric motor which provides adequate power for general purpose pumping.
components 1 2 3 7 4 6 33 5 Figure 1. Submersible Pump Components Figures 1 shows the location of the basic components for the SS233 submersible pump. Listed below is a brief explanation of each component. 1. AC Power Cable — This unit is supplied with a 20 ft. (6.1 meters) AC power cable. Always check the cable for signs of wear. NEVER! use a defective power cable. Replace the cable immediately if the cable is worn or defective. 2.
operation 1. Attach a suitable lifting cable (rope) to the carrying handle (Figure 2) on the pump and lower the pump into place. For applications where there is an excessive amount of mud, grit or silt, the use of a support platform is desirable. When pumping water from swimming pool type applications where there is little or no debris, the support platform is not required. 2. Make sure the pump is always placed in an upright position, not tilted (Figure 3).
operation 4. NEVER! grab or touch a live power cord (Figure 4) with wet hands, the possibility exists of electrical shock, electrocution and even death. 6. Wait a few seconds and water should begin to flow from the discharge hose. 7. If water is not flowing from the discharge hose or not flowing freely after a few minutes, remove the power from the pump and check the system for leaks. Pump Shut-Down/Clean-up 1.
troubleshooting Symptom Pump Fails To Start Pump Fails to Deliver Full Output Table 2. Pump Troubleshooting Possible Problem Solution Check that proper voltage (115 VAC 1Ø) is being supplied to the pump. Also check that there is an adequate Incorrect voltage/amps? amount of current (amps) to run the pump. Check power source circuit breaker. Check electrical connections? Inspect power cord. Replace fuse or circuit breaker.
Explanation of Code in Remarks Column The following section explains the different symbols and remarks used in the Parts section of this manual. Use the help numbers found on the back page of the manual if there are any questions. NOTICE The contents and part numbers listed in the parts section are subject to change without notice. Multiquip does not guarantee the availability of the parts listed. Sample parTS liST no. 1 2% 2% 3 4 parT no. parT name QTY. remarKS 12345 BOLT......................1 .....
notes SS233 Submersible Pump • operation and parts manual — rev.
pump assy. 1 2 3 33 page 16 — SS233 Submersible Pump • operation and parts manual — rev.
pump assy. NO. 1 2 3 PART NO. 020177 020246 SS233 PART NAME QTY. REMARKS CABLE 20 FT 1 FITTING, 2" NPT 1 SUBMERSIBLE PUMP.......................................1................CONTACT MQ UNIT SALES SS233 Submersible Pump • operation and parts manual — rev.
Terms and Conditions of Sale — Parts paYmenT TermS 5. Parts must be in new and resalable condition, in the original Multiquip package (if any), and with Multiquip part numbers clearly marked. 6. The following items are not returnable: Multiquip reserves the right to quote and sell direct to Government agencies, and to Original Equipment Manufacturer accounts who use our products as integral parts of their own products. a. SpeCial eXpediTing ServiCe Terms of payment for parts are net 30 days.
notes SS233 Submersible Pump • operation and parts manual — rev.
Operation and Parts Manual HERE’S HOW TO GET HELP PLEASE HAVE THE MODEL AND SERIAL NUMBER ON-HAND WHEN CALLING UNITED STATES Multiquip Corporate Office 18910 Wilmington Ave. Carson, CA 90746 Contact: mq@multiquip.com MQ Parts Department Tel. (800) 421-1244 Fax (800) 537-3927 Mayco Parts 800-427-1244 310-537-3700 Fax: 800-672-7877 Fax: 310-637-3284 Warranty Department 800-306-2926 310-537-3700 Fax: 800-672-7877 Fax: 310-637-3284 Service Department 800-421-1244, Ext. 279 310-537-3700, Ext.
