Portable Generator User Manual

SG1400C3 STUDIO GENERATOR • OPERATION MANUAL — REV. #0 (10/05/11) — PAGE 27
DIGITAL CONTROLLER
Refer to Figure 9 for location of controls and indicators.
1. STATUS LED — Indicates status of the controller.
Lights green when the controller is running.
NAVIGATIONS BUTTONS
2. ARROW UP Button — Press button to scroll up
through the status menus or programming prompts.
3. ARROW DOWN Button — Press button to scroll down
through the status menus or programming prompts.
4. MENU Button — Press button to jump to menu/sub-
menu page or escape from any dialog window.
5. ENTER Button — Press button to confirm a value or
open a value adjustment within setting dialogs.
CONTEXT BUTTONS
6. MODE Button — Press button to jump to the controller
mode window.
7. HISTORY Button — Press button to jump to history
screen.
8. ALARM Button — Press button to jump to alarm list
9. GCB (Generator Circuit Breaker) CONTROL
Button — Press button to close/open GCB.
10. MCB CONTROL Button — Not functional in this
application.
CONTROL BUTTONS
11. START Button — Press button to go idle mode (about
an hour) then generator starts. A second press will
bypass idle mode and generator goes to full speed
immediately.
12. STOP Button — Press button to cool the generator
for about 5 minutes then the generator will stop. A
second press will bypass cool down and will stop the
generator immediately.
13. FAULT RESET Button — Press button to acknowledge
faults and alarms (active only in Alarm screen).
14. HORN RESET Button — Press button to deactivate
the horn (audible alarm).
15. DISPLAY — Shows menu, measurements, setpoints,
alarm list, history, and help/others screens.
NOTICE
START and STOP buttons work in MAN (manual) or
SEM (semi-manual) mode only.
NOTICE
For more detailed operating and programming
information on the digital controller, refer to the
InteliVision 5™ Controller User's Guide.
Figure 9. Digital Controller
1
4
5
2
3
6
7
11
14
13
12
15
10
9
8