Instruction Manual


COMPONENTS
30
33
34
32
26
31
31
REAR VIEW FRONT VIEW
24
25
2728
Figure 5. Major Components (Front/ Rear)
24. Rear Reflectors — There are two reflectors mounted
on the rear light tower panel. These reflectors provide
better visibility in dark conditions.
25. Engine Exhaust Pipe — Directs engine exhaust to the
rear of the light tower.  block this exhaust pipe
with obstructions. ALWAYS place the light tower in an
area free of obstructions.
26. — Before towing the light tower, make
sure that this light is operational and is working correctly.
 tow the light tower if this light is inoperative.
27. — Before towing the light tower, make
sure that this light is operational and is working correctly.
 tow the light tower if this light is inoperative.
28. License Light — This light illuminates the license plate.
Whenever towing of the light tower is required, make
sure this light is operational.
29. — There are two
jackstands located at the rear of the trailer. Use these
jackstands and outriggers to level and support the light
tower.
30. Tires — This light tower uses a ST175-80D size tire.
Replace with only recommended tire size.  tow
light tower with bad or worn tires.
31. — There are two
jackstands located at the front of the trailer. Use these
jackstands and outriggers to level and support the light
tower.
32.  — This area of the light tower
encloses the components for the ballast assembly
lights 1 and 3 (top).
33.  — This area of the light tower
encloses the components for the ballast assembly
lights 2 and 4 (bottom).
34. Ground Point — Grounding requirements differ by
application, state, and agencies. If more definitive earth
to ground connections are required, see NEC guidelines
and use this established grounding point.