user manual


SAFETY INFORMATION



To prevent serious burns,  touch
or unzip the balloon envelope when the
lamp is on.


ALWAYS keep the balloon away from sharp objects and
excessive amounts of heat.
NOTICE

To prevent balloon deformation,  use lighting
system in strong winds.

 place the balloon inside its protective cover
until the lamp has had a suffi cient amount of time to cool
down. This will prevent the balloon’s nylon cover from
being burned (touching the lamp surface).

ALWAYS place the balloon inside its protective cover
after each use. This will prolong the life of the balloon
material, keeping it protected from harsh environmental
elements.

Replace balloon immediately if damaged. A damaged
balloon will not infl ate properly, and may become more
damaged by touching the hot lamp surface.

 use excessive force when zipping and unzipping
the balloon. Be gentle with the zipper mechanism. If the
zipper is broken, the balloon will become unusable.

If using a generator to power lighting system,
refer to applicable generator manual safety
information section.



Lighting system is equipped with a ground pin on the
power plug. For your protection, ALWAYS
complete the
grounding path. 
insert the AC power plug into a
2-prong receptacle to operate lighting system.
When applying power to the lighting system,
ALWAYS
connect the AC power plug to a 3-prong receptacle that
is grounded. The possibility exists of


if the lighting system is
not grounded.
  operate lighting system or
handle any electrical equipment while
standing in water, while barefoot, while
hands are wet or in the rain. A dangerous
 could occur, causing

 ALWAYS make sure the area above
the lighting system is open and clear
of overhead power lines and other
obstructions. Contact with overhead
power lines or other obstructions could
result in equipment damage, 



  let power cords or cables 
  use  or 
cables or cords. Inspect
for cuts in the insulation
  grab or touch a live power
cord or cable with wet hands. The
possibility exists of 


Make sure power cables are securely connected.
Incorrect connections may cause 
and
damage to the lighting system.
NOTICE
 ALWAYS
make certain that proper power or extension
cord has been selected for the job. See Cable Selection
Chart in this manual.