Owner manual
ga6HR/6HRS
INSPECTION/SETUP
1. Read safety instructions at the beginning of manual.
2. Clean the generator, removing dirt and dust, particularly
the engine cooling air inlet, carburetor and air cleaner.
3. Check the air filter for dirt and dust. If air filter is dirty,
replace air filter with a new one as required.
4. Check carburetor for external dirt and dust. Clean with
dry compressed air.
5. Check fastening nuts and bolts for tightness.
1. Place the battery into the battery cradle and secured
with mounting hardware.
2. Connect the positive cable to the positive terminal on
the battery first, then connect the negative cable to the
negative terminal.
1. To check the engine oil level, place the generator on
secure level ground with the engine stopped.
2. Remove the filler dipstick from the engine oil filler hole
(Figure 10) and wipe clean.
Figure 10. Engine Oil Dipstick Removal
NOTICE
place the main circuit breaker in the
position prior to starting the engine.
Use all safety precautions specified by the battery
manufacturer when working with the battery. See Safety
Information section of this manual for more details on
battery safety.
3. Insert and remove the dipstick without screwing it into
the filler neck. Check the oil level shown on the dipstick.
4. If the oil level is low (Figure 11), fill to the edge of the
oil filler hole with the recommended oil type (Table 5).
Maximum oil capacity is 1.16 quarts (1.1 liters).
Figure 11. Engine Oil Dipstick(Oil Level)
Summer 25°C or Higher SAE 10W-30
Spring/Fall 25°C~10°C SAE 10W-30/20
Winter 0°C or Lower SAE 10W-10
1. Close the fuel cock before filling the fuel tank.
2. Remove the fuel cap located on top of fuel tank.
3. Read the fuel gauge located on top of the fuel tank
(Figure 12) to determine if the fuel level is low. If fuel
is low, replenish with clean unleaded fuel.
Figure 12. Fuel Gauge
4. When refueling, be sure to use a strainer for filtration.
top-off fuel. fill the tank beyond
capacity. Wipe up any spilled fuel immediately!