Specifications

DCA70SSJU4i — LOAD BANK INSTRUCTIONS P/N EE58627 — REV. #1 (03/13/15) — PAGE 4
ROOF COVER/RESISTOR LOAD BANK
INSTALLATION
Use the procedure below to mount the Resistor Load Bank
(P/N EE58325) into the Roof Cover (P/N EE58361).
1. Lift the Resistor Load Bank (Figure 7) upward and
align mounting ear holes with flange bracket holes on
Roof Cover.
2. Secure Resistor Load Bank to Roof Cover using three
6MM hex head screws. The fourth 6MM screw is for
the GND. wire.
Figure 7. Roof Cover/Resistor Load Bank
Installation
3. Connect the ground wire to the Resistor Load Bank as
referenced in (Figure 7).
4. Using 6MM screw (12) with lock washers and flat
washers (Figure 8), install Cover Plate (P/N EE58362)
onto A and B sides of Roof Cover (P/N EE58361).
A1
A2
A3
A4
A5
A6
A12
A11
A10
A9
A8
A7
R1
R2
R3
R4
R5
R6
R12
R11
A10
R9
R8
R7
SIDE A
RESISTOR
LOAD BANK
P/N EE58325
ROOF COVER
P/N EE58361
GND. WIRE
TERMINAL
RING
1
4
2
3
Figure 8. Cover Plate Mounting
5. Place and align the Roof Cover (P/N EE58361) on top
of cabinet housing as shown in Figure 9.
Figure 9. Roof Cover Mounting
6. Use the mounting hardware removed in the "Front
Frame Exhaust Cover", step 2 to secure the Roof Cover
to the cabinet housing.
7. Tighten all screws securely.
COVER ROOF ASSY.
P/N EE58361
COVER PLATE (2)
ASSY. P/N EE58362
6MM MOUNTING
SCREW (12)
WITH LOCK/FLAT
WASHERS
SIDE A
SIDE B
ROOF COVER
P/N EE58361
CABINET HOUSING
MOUNTING
HARDWARE