User Manual

PAGE 20 — C10SH8-PH8 CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #0 (03/06/09)
OPERATION
STARTING THE ENGINE
The following steps outline the procedure for starting the
engine. Depending on the type of engine employed in the
mixer, the steps may vary slightly.
Move the fuel shut-off lever (Figure 7) to the ON 1.
position.
Fuel Shut-Off LeverFigure 7.
To start a cold engine, move the choke lever (Figure 2.
8) to the CLOSED position.
Choke LeverFigure 8.
Move the throttle lever (Figure 9) away from the slow 3.
position, about 1/3 of the way toward the fast position.
Throttle LeverFigure 9.
Turn the engine switch (Figure 10) to the ON position.4.
Engine ON/OFF SwitchFigure 10.
Located at the rear of the mixer frame is the main start/5.
stop button (Figure 11). Pull this button outward to start
the engine.
Engine Start/Stop ButtonFigure 11.
Pull the starter grip (Figure 12) lightly until you feel 6.
resistance, then pull briskly. The drum should be
rotating at this time.
Starter GripFigure 12.