Operation Manual
Receiver
Page 62
SMART SX FLEXX
4 Receiver
The RX-5 M-LINK receiver with Smart ID is included in the scope of delivery of the
set.
4.1 Controls
Fig. 3: RX-5 light M-LINK ID 1 receiver
1
Status LED
Rapidly flashing yellow light: binding mode
Slowly flashing yellow light: normal mode
2
SET button
3
Servo sockets, channel 1 to 5
4.2 Fail-Safe
The receiver is equipped with a Fail-Safe function. If the transmitter fails, the
servos assume the pre-programmed positions.
This significantly increases reliability when using a model. Move the actuators on
the transmitters to a position where the servos assume the desired position. Once
this is the case, press the SET button on the receiver.
This stores the Fail-Safe positions permanently in the receiver. They can be
overwritten with new positions at any time by pressing the button again.