Operation Manual
Instructions
Page 57
ENGLISH
Appendix 1: Factory Settings
1. Assignment of controls and switches
The table shows the factory settings of the assignment lists 1, 2 and 3 for controls and switches. List 4 and 5 are not
predefined. All 5 lists can be modified freely.
When modification is carried out a warning message appears in the display: „Standard list! Please note: changes affect
all models and templates using this list!“
Assignment no
Name
1.
MOTOR
2.
SEGLER
Assignment no.
Name
3.
HELI
4.
4....
5.
5....
Controls:
Throttle
(Idle)*
Spoiler
Flap/RPM
L. gear
Tow rel.
Brake
Gyro
Mixture
AUX1
AUX2
Collect.
Thr.lim.
Switches:
DR-ai
DR-el
DR-ru
CombiSwitch
Throttle-cut
µ Slot
´ Sum
¶¶ Interval
Mix-1
Mix-2
Mix-3
Teacher
Main hase
Phases 1-3
‡ #
E '
F #
---
---
---
---
---
---
---
---
---
L #
L #
L #
N #
H „
---
‡ '
---
G #
---
---
---
---
O '
E #
‡ '
F #
---
---
---
---
---
---
---
---
---
L #
L #
L #
N #
H „
---
E '
---
G #
---
---
---
---
O '
Controls:
Throttle
Spoiler
Flap/RPM
L. gear
Tow rel.
Brake
Gyro
Mixture
AUX1
AUX2
Collect.
(Minimum)*
Thr.lim.
(Minimum)*
Switches:
DR-ai
Roll
DR-H
Pitch
DR-S
Yaw
CombiSwitch
Direct Thr.
Gas-NOT-AUS
µ Slot
´ Sum
¶¶ Interval
MIX-1
Heading/Damping
Mix-2
Mix-3
Teacher
Main phase
Autorotation
Phases 1-3
---
---
---
---
---
---
E '
---
---
---
‡ #
F #
L #
L #
L #
N #
H „
---
F '
---
---
---
---
---
I #
O '
()* The arrow after the controls name refers to this option.
E x a m p l e : T h r o t t l e ‡ #means, throttle is controlled by the stick, idle position is back
More about assignment see paragraph 13.3
NOTE for controls! Where ist he idle/neutral position?
Move th control to the desired idle/neutral position and confirm by pressing ENTER. The chosen position is now memo-
rised.
The arrow after the controls name indicates the idle/neutral position ( # / ' ). The asterisk ( * ) appears if the control is in
idle or neutral position.
NOTE for switches! Where are the ON and OFF positions?
The arrow l (#/') after the identifying letter always points towards the ON position. Move the switch to the desired ON
position and confirm by pressing ENTER (or one of the 3-D digi adjustors). The chosen position is now memorised.