Operation Manual

Instructions
Seite 31
ENGLISH
12.10. Template: 4-Flaps
suitable for:
F3B, F3J,
Glider with four wing flaps, with electric power,
with V-tail
Typical models:
DG 600, ASW 27, Milan, E
URO
/E
LEKTRO
-M
ASTER
,
Alpina (fig. below), ASH 26
12.10.1. Assigned transmitter controls and
switches
Assignment used: GLIDER+
A
: Sum timer
´
controlled by throttle (E)
Dual-Rate Combi- Mix-1
A/E/R Switch (elevator to aileronl)
OFF OFF OFF
Phase 1-3 Throttle Flap
1: NORMAL Idle neutral
12.10.2. Assigned servos / receiver outputs
1
2
4
5
6
3
7
8
9
Spoiler
Spoiler
AILERON+
Throttle
AILERON+
ELEVATR+
Rudder
FLAP+
FLAP+
Í Aero-tow release instead of throttle: see 12.9.3.
12.10.3. Fine-tuning
!
Steps a. and b. (Î 12.4.)
c. Butterfly
This function is already programmed in the te m-
plate, and is operated using the transmitter control
Spoiler (slider E). You may have to adjust the com-
pensation ratio (15%) in the ELEVATOR+ mixer.
d. Activate throttle - elevator mixer
select G, ELEVATR+, input Thr -Tr ,
set 10% down elevator
For fine adjustment in flight assign the value to the
3-D digi-adjustor.
12.11. Template: HELImech
suitable for:
Main rotor control systems with mechanical mixers
Typical models:
Ergo, Futura, Moskito, Raptor
12.11.1. Assigned transmitter controls and
switches
Assignment used: HELI
A
: Sum timer
´
controlled by THR.LIMITER (F)
Dual-Rates Direct Main Trottle-
A/E/R Throttle phase Cut
OFF OFF OFF
Phase 1-3 Gyro Thr. limiter (Direct Thr.)
1: SCHWEBEN Centre Minimum
12.11.2. Assigned servos / receiver outputs
12.11.3. Fine Tuning
a. Check stick functions (roll, pitch-axis, yaw)
Select different mode if necessary ( 13 .3.1 .)
L, Assignment, Mode
b. Check direction of servo rotation for all functions
If necessary change servo direction (REVERSE)
K, Calibrate, select servo, Parameter REV/CLR
c. Gyro features
Î 15.3.