Operation Manual

ROYAL evo
Seite 30
12.8. Template: DELTA
suitable for:
Deltas and flying wings powered or glider,
Model Jets
Typical models:
PiCOJet, TWIN-JET (fig. 12.7.2.), Stuntman
12.8.1. Assigned transmitter controls and
switches
Assignment used POWER
not used: Combi-Switch (N)
Spoiler (E), Flap (F)
A
: Sum timer
´
controlled by throttle (
‡
)
Dual-Rates Throttle-cut
A/E/R (button)
OFF
Phase 1-3
1: NORMAL
12.8.2. Assigned servos / receiver outputs
1
5
4
DELTA+
Throttle
DELTA+
12.8.3. Fine-tuning
!
Steps a. and b. (Î 12.4.)
c. Using a receiver with fewer than 5 channels
Change servo assignment: K Assignment
e.g. 1=DELTA+, 2=DELTA+, 3=Throttle
d. Control surface travels excessive or insufficient
select G mixer DELTA+,
change elevator and/or aileron inputs
e. Activate throttle - elevator mixer
select G, ELEVATR+, input Thr -Tr ,
set 10% down elevator
For fine adjustment in flight assign the value to the
3-D digi-adjustor.
12.9. Template: GLIDER
suitable for:
Gliders with two wing flaps (i.e. ailerons only),
with electric power, with V-tail
Typical models:
Flamingo, Kranich, Alpha 21/27
12.9.1. Assigned transmitter controls / switches
Assignment used: GLIDER+
not used: Flap (F)
A
: Sum timer
´
controlled by throttle (E)
Dual-Rates Combi- Mix-1 Throttle-cut-
A/E/R Switch (ele-ail) (button)
OFF OFF OFF
Phase 1-3 Throttle
1: NORMAL Idle
12.9.2. Assigned servos / receiver outputs
1
2
4
5
3
6
7
AILERON+
Throttle
AILERON+
ELEVATR+
Rudder
Spoiler
Spoiler
If your model has an aero-tow release mechanism
instead of a power system, you can use servo 4 to oper-
ate it. The following steps are required:
1. Assign control
L, Assignment, Control, then select Tow rel.
and an element to operate it (e.g. button M)
2. Servo zuordnen
K , Zuordnung, Servo 4 wählen und von Gas in
Kupplung ändern
3. Servo einstellen
Drehrichtung und Endlagen für Servo 4 werden
unter K, Abgleich eingestellt.
12.9.3. Fine-tuning
!
Steps a. and b. (Î 12.4.)
c. Ailerons raised as landing aid...
... if your model has no airbrakes
(Servos 6/7).
select G , AILERON+, set Spoiler input to 90%
Adjust the compensation ratio if necessary
in ELEVATR+
d. Activate throttle - elevator mixer
select G, ELEVATR+, input Thr -Tr ,
set 10% down elevator
For fine adjustment in flight assign the value to the
3-D digi-adjustor.