Operation Manual

ROYAL evo
Seite 28
Assign the function Mixture to the receiver output to
which the mixture adjustment servo is to be connected,
and select 5P (Î 16.2.3) for the servo calibration. The
mixture can now be adjusted accurately in the menu K
Servo, Calibrate, Mixture (Î 16.1) , so that it suits all
positions of the throttle servo.
12.4. Model templates in detail
The following sections contain detailed descriptions of
all the model templates which are present in your
ROYALevo.
In each template description you will first learn the
types of model for which the template is suitable.
The first section (12.x.1.) tells you which transmitter
controls and switches are assigned. The drawing also
shows how the various switches and transmitter con-
trols must be set to ensure that the model can be
switched on in as safe a state as possible.
The second section (12.x.2) includes a drawing showing
the receiver outputs to which the servos (speed control-
ler, gyro) have to be connected. This sequence can be
changed in any way you wish (Î 16.2.).
The third section contains (12.x.3.) notes on how to
adjust the model to meet your specific needs and pref-
erences.
!
The next two steps must always be carried out
when you start programming a new model.
a. Check the stick functions (aileron/elevator/rudder); if
necessary select a different mode (Î 13.3.1.)
L, Assignment, Mode
b. Check the direction of servo rotation for all functions,
if necessary reverse the directions (REVERSE)
K, Calibrate, select servo, Parameter REV/CLR
Note for V-Tail models
If your model has got a V-Tail the assignment in
the menu Servo K m u s t b e c h a n g e d . O n l y a f t e r
this has been done, the mixer V-TAIL+ appears in
the mixers menu G .
Elevator or ELEVATR++
must be replaced by V-TAIL+
Rudder
must be replaced by V-TAIL+
12.5. Template: BASIC
suitable for:
simple power models
models with one or two aileron servos,
models with spoilers (landing flaps or airbrakes)
Typical models:
Lupo, PiCO-CUB, Movie Star (fig. 12.4.2.), Twin-
Star, Big Lift
12.5.1. Assigned transmitter controls and
switches
Assignment used: POWER
not used: Flap (F)
A
: Sum timer
´
controlled by throttle (
‡
)
Dual-Rates Combi-Switch Throttle-cut
A/E/R (button)
OFF OFF
Phase 1-3
1: NORMAL
12.5.2. Assigned servos / receiver outputs
To ensure that the template can be used for as many
model types as possible, more servos can be assigned
than are required for the model shown in the drawing.
1
5
4
3
6
2
Aileron
Throttle
Aileron
Rudder
Spoiler
ELEVATR+
12.5.3. Fine-tuning
!
Steps a. and b. (see left)
c. Activate throttle - elevator mixer
select G, ELEVATR+, input Thr -Tr ,
set 10% down elevator
For fine adjustment in flight assign the value to the
3-D digi-adjustor.