Operation Manual

Instructions
Seite 21
ENGLISH
Note:
If the area of the screen is not sufficient to list all the
sub-menus, you will see arrows „ © “ or „ ª “on the
left-hand edge of the screen. You can then “leaf
through” the list up or down using the UP/DOWN (V /
W) arrows, or alternatively one of the two 3-D digi-
adjustors, in order to reach the end or beginning of the
list. This is very similar to the process of “scrolling” in a
PC program. Example:
10.3.3. Changing values
Switching the display language is used as an example.
Starting from the status display you must proceed as
follows:
1. Press the L button
This opens the menu Setup. You can now select
the sub menu User using the UP/DOWN buttons
V W or alternatively one of the two 3-D digi-
adjustors. To move to the sub-menu press ENTER
(or).
2. Now select the parameter “Sprache” (German word
for language)with the UP/DOWN buttons V W (or
one of the 3-D digi adjustors).
3. Press the ENTER button (or one of the 3-D digi
adjustors) to release the parameter for changing.
With the UP/DOWN buttons V W (or one of the 3-
D digi adjustors) you can now select one of the two
languages:
Your selection is confirmed by pressing ENTER (or
one of the 3-D digi adjustors) and you will leave
the parameter field.
Note on memorisation of modifications:
Modified values/settings are stored immediately in
the model memory. No manual storing procedure is
required.

TIP !
Using the REV/CLR button
The value of a parameter can be changed using the
UP/DOWN (V W) buttons or one of the two 3-D digi-
adjustors, but in addition REV/CLR button can also be
used to reverse many values, or reset them to the de-
fault (standard) setting.
10.3.4. Returning from whence you came
When you quit the value/setting field the cursor moves
back to the last used parameter field.
To leave the sub-menus and main menus simply move
to the 2nd line „¨ Exit “ and then press the ENTER
(or one of the 3-D digi adjustors), until you return to the
status display.
Fig. 1 Fig. 2

TIP !
Direct switching to other main menus
If you are in one menu and wish to move straight to
another main menu, you can do this directly by pressing
the relevant direct menu access button.

TIP !
Back to the status display
Pressing any direct menu access button twice takes you
quickly and directly to the status display you last used
(provided that you are not currently located at a pa-
rameter value).