Operation Manual

ROYAL evo
Seite 20
10.3. Working with the keypad and
3-D digi-adjustor -the fundamental
operating philosophy
These instructions have already described how to
switch the transmitter on, the type of status display, and
the information and method of operating the status
displays (Î 9.1. / Î Fehler! Verweisquelle konnte
nicht gefunden werden..).
The following section explains the operating philoso-
phy of the ROYALevo and the methods of working with
the keypad and 3-D digi-adjustors, using the example of
changing the screen language. The starting point is one
of the status displays 1-4 (Î Fehler! Verweisquelle
konnte nicht gefunden werden..).
10.3.1. Calling up main menus
To move to the transmitter’s menu level, the direct
menu access buttons are required (Î10.1.1..), and they
are also used for programming. Six main menus are
present in total, all of which contain appropriate sub-
menus:
L
SETUP (configuration (Î 13.)
Transmitter
Mixer definitions
Assignment
Training
User
H
CONTROL (Î 14.)
Access to the individual set-up menus for the
transmitter controls. The screen only displays
those controls which are used in the current
model (=> dynamic menu).
G
MIXER ( Î 15.)
Access to the individual mixer menus. The
screen only displays those mixers which are
used in the current model (=> dynamic menu).
K
SERVO (Î 16.)
Calibrate
Assignment
Monitor
Test run
A
TIMER ( Î 17.)
Model/memory operating time
Slot timer
Sum timer
Interval timer
I
MEMORY ( Î 18.)
Select or change model
Copy model
Erase model
Flight phase management
Model properties
Create new model
Press the corresponding direct menu access button to
call up a main menu.
(Example, switch language: L button)
The following display appears:
The first line indicates the main menu in which you are
currently located (example main menu Setup: „L
Setup“).
The second line always shows „¨ Exit“.More on this:
(Î 10.3.4.).
The following lines list the associated sub-menus. Four
dots .... after the name of the sub-menu indicate that
additional menus (sub-menus) are present.
10.3.2. Opening sub-menus
You can now select one of the sub-menus line by line
using the UP/DOWN buttons (V / W)*), or alternatively
one of the two 3-D digi-adjustors. The selected line is
always highlighted (displayed in inverse video). This
corresponds approximately to the cursor of a PC.
(Example: language switch: sub-menu „ User “ )
To open a sub-menu press the “ENTER” button, or alter-
natively one of the two 3-D digi-adjustors.
The sub-menu opens.
To help you keep track of your movements, the first line
displays the symbol of the current main menu and the
name of the current sub-menu.
(Example language switch:
Main menuSetup: „L“ / sub-menu „ User “ )