Operation Manual

ROYAL evo
Seite 12
4. Connect the bare wire ends to the appropriate
screw-terminals on the main circuit board; you will
need a small slot-head screwdriver for this. It does
not matter which way round the wires are con-
nected.
Fig. 1:
Fig. 2:
Advice for stick button/switch alignment
If a stick handle with button/switch is installed fort the
first time in the transmitter the alignment is done
automatically. Re-alignment is necessary, if the stick
handle is exchanged. To initiate re-alignment check in
the data manager the option box for “Reset stick but-
ton/switch alignment” (Î 19.6.). For more information
see the DataManager instructions.
7.4.11. Installing the optional switches “P” and “K”
If you need extra functions 2-position switches can be
installed in the installation wells “P” and “K”. To fit them
the corresponding corner unit must be removed from
the transmitter:
1. Locate the TORX screwdriver (in a clip below the
aerial guide sleeve, close to the screen) and undo
the four TORX screws holding the appropriate stick
unit (Fig. 1).
2. Check that the switches are at the centre position,
then carefully withdraw the corner unit from the
transmitter. Remove the rotary knob (push-fit) from
the 3-D digi-adjustor when you withdraw the unit
(Fig. 2).
3. Use a small screwdriver to push out the blind cover
from the inside.
4. Fit the switch and secure it with the retaining nut
supplied (Fig. 3). Note the correct orientation: the
red wire should face the battery.
5. Re-install the corner unit, fit the retaining screws
and push the rotary knob back onto the 3-D digi-
adjustor (note correct position: internal index
shoulder). Connect the plug attached to the new
switch directly to the micro-connector on the cor-
ner unit (Fig. 4).
Fig. 1:
Fig. 2:
Fig. 3:
Fig. 4: