Operation Manual

ROYAL evo 7 - Instructions
Page 13
ENGLIS
H
9.3. Rear face of transmitter
c Two sliding latches (OPEN) allow the transmitter to
be opened and closed quickly and easily, e.g. for chang-
ing the crystal or RF module (Î 9.5.3.).
d The strong handle provides a safe method of carry-
ing the transmitter, and also protects the rear face of
the transmitter when it is placed on the ground.
e MULTIPLEX multi-function socket
As usual with MPX, the ROYALevo also features a MUL-
TIPLEX multi-function socket (marked “CHARGE”) as
standard. It is used for the following functions:
x charging the transmitter (Î 8.)
x connecting socket for Trainer mode operations
(Î 13.4.)
x PC interface, for backing-up model data
(Î 23.1.1.)
x PC interface, for updating the transmitter
(Î 23.1.1.)
x PC interface, for use with flight simulators
x interface for diagnosis mode operations; connects to
a receiver by cable for programming and adjustment
work without transmitting an RF signal (Î 22.6.).
9.4. Inside the transmitter
c The transmitter battery installed as standard con-
sists of six environmentally friendly, high-capacity AA-
size NiMH (Nickel-Metal-Hydride) cells. For safety rea-
sons the cells are factory-assembled and protected in a
heat-shrink sleeve.
! Use only genuine MULTIPLEX transmitter bat-
teries! Be sure to observe the notes on battery
charging!
(Î 8.)
The transmitter battery is fitted with a special
thermo-fuse which protects the battery and - es-
pecially - the transmitter from short-circuit, re-
versed polarity and excessive currents. The trans-
mitter does not feature a separate fuse, and for this
reason a genuine MPX transmitter battery de-
signed for this equipment must be always be fitted
if the pack ever needs to be replaced.
d RF module (Radio Frequency module)
The RF module is simply plugged into the main circuit
board. It can easily be changed, for example, to use a
different frequency band (Î 9.5.3.). Two different RF
modules can be used in the ROYALevo:
HFM-4:
A simple, low-cost RF module accepting plug-in crystals
for selecting the channel / transmitter frequency.
Use only genuine MULTIPLEX transmitter crystals!
The “Channel-Check“ power-on security module can be
fitted to this RF module at any time.
HFM-S:
A modern synthesizer RF module with software-
selectable channel / transmitter frequency.
A scanner with power-on guard can
be retro-fitted.
e The TORX
£
screwdriver (size
T6), which fits in a clip under the ae-
rial well, is used to swivel the stick
units and similar tasks.
f The inside of the transmitter back panel features 3
crystal holders for spare crystals:
! Slide the crystals out - don’t lever them out!
e
c
d
f
cd
e