Operation Manual

ManualsBrandsMultiplex ManualsMiscellaneousROYALevo7

ROYAL evo 7 - Instructions

Page 11

ENGLIS

9. The transmitter

9.1. Front face of transmitter

You will find the following controls on the front face of

the transmitter:

c Two precision stick units, for controlling the four

primary axes. The ratchet for the throttle / spoiler stick

can be positioned right or left (Î 9.5.6.). Both stick units

can be swivelled to suit your personal preference (Î

9.5.8.). The swivelling stick tops are infinitely adjustable

in length.

d Two sliders “E” and “F” are fitted as standard and

can be assigned to any channel. They also operate as

switched functions with centre detent.

e Two digital cruciform trim units below the stick

units for trimming the primary control axes, each con-

sisting of one pair of buttons for left/right and up/down

(Î12.).

f Audible sounder (piezo beeper).

g The RF status display / LED (red light-emitting di-

ode) indicates whether an RF (Radio Frequency) signal is

being radiated when the transmitter is switched on:

LED glowing constantly o n o R F t r a n s m i s s i o n

LED flashing every 2 sec. o RF transmission occurring

The LED is controlled according to the current drain of

the RF module. For example, if the transmitter crystal is

absent or faulty, no RF signal can be generated, and the

constantly glowing LED warns you that no RF signal is

being transmitted.

h Keypad consisting of 11 buttons in 2 rows. The six

buttons in the first row provide fast, direct access to the

6 main menus (direct menu access buttons). The 5 but-

tons in the second row are used for programming.

Apart from the “ENTER” button all buttons have a sec-

ondary function for entering text. Text is input using the

method commonly adopted for mobile telephones.

i ON/OFF switch (“O” / “1”).

j The screen is a modern, UV-stable graphic LCD

panel (132 x 64 dots) with an anti-reflective surface.

Screen contrast is variable (Î 13.1.4.). The screen can

be tilted in two stages through a maximum of about 40°

in order to obtain the optimum viewing angle.

k Two 3D digi-adjustors are used for programming

and adjustment work. They are a standard feature, and

are permanently installed. For programming, both work

in parallel with the “ENTER” button or the “” (UP) /

“” ( D O W N ) b u t t o n s w h e n p r e s s e d o r r o t a t e d . I t i s p o s -

sible to assign many different settings / parameters to

the 3D digi-adjustors, so that you can easily and directly

carry out adjustments in flight (Î 11.2.2.).

l Lug for connecting a neck strap

(e.g. # 8 5161 or # 8 5646).