Operation Manual

Manual
97
V-TAIL+
*
Elevator
trv' = Control surface deflection
for down-elevator
trv# = Control surface deflection
for up-elevator
Rudder
trv' = Control surface deflection
for rudder in one direction
(e.g. up)
trv# = Control surface deflection
for rudder in the other di-
rection (e.g. down)
Spoiler
Elevator trim correction for Spoiler
(airbrakes):
pt1 = Elevator compensation for
half-deployed spoilers
pt2 = Elevator compensation for
fully deployed spoilers
Flap
Elevator trim correction for Flap:
trv' = Elevator com
p
ensation for
(e.g.) Thermal setting
trv# = Elevator compensation for
(e.g.) Speed setting
Thr -Tr
Elevator trim correction for throttle
(motor):
dead = Dead-zone / from which
point does elevator cor-
rection take effect?
trv = Elevator compensation for
full-throttle
* only appears if V-TAIL+ is active
21.1.3.
HOTLINER model template
Suitable for:
F5B.
Typical models:
BLIZZARD (V-tail required (Î 21.1.)), Bonito,
Akro, Akro Star.
Assigned transmitter controls and switches:
Assignment used:
POWER
Not used: Combi-Switch (N),
Spoiler (E), Flap (F).
You will find an overview of the global assignment of
transmitter controls and switches in Chapter (Î 22.1.).
Assigned servos / receiver outputs:
1
2
5
4
AILERON+
Throttle
AILERON+
ELEVATR+
Servo configuration MPX-UNI
Timer setting: Motor run time
Sum timer ´ controlled by Throttle (‡).
Fine-tuning:
!
Steps a. and b. (Î 21.1.),
Check functions.
c. Ailerons raised as landing aid
This function is already programmed in the tem-
plate (all mixer inputs =
0%) and is operated using
the transmitter control
Spoiler (slider E). You
may need to add the trim correction input (
15%) to
the
ELEVATR+ mixer.
d. Activate throttle to elevator mixer
G, select
ELEVATR+, select Thr -Tr input,
set
10% down-elevator.
If you wish to adjust the value in flight, allocate it to
one of the 3-D digi-adjusters (Î 20.1.).