Operation Manual

ROYAL pro
84
18.5.2. Summary Timer 3 ¶¶Interval
Effect For active model only,
the current status is not
stored when the
transmitter is switched off or you change
the model memory.
With alarm = 0:00:00 behaves as Sum
timer, otherwise counts down
Start Runs as long as the assigned switch
(switch / slider / stick) is at the ON posi-
tion
Reset REV/CLR button in the menu
or in Status display 4 (Timer),
or when re-started using the associated
switch
Range 3:30:00 (3 h 30 min)
Alarm 2 sec before elapse of alarm time:
one triple beep (;;;Ò) per second.
When the alarm time is reached:
long triple-beep
(;;;ÒœőŖœőŖœőŖ),
followed for five seconds by:
audible signal
The triple beep identifies the timer as Timer 3, Interval
18.6. Total transmitter operating time
The fifth timer records the transmitter’s operating time,
and is only displayed in Status display 4 (Î 10.6.4.):
...
...
Operation time 44.8h
After a total transmitter operating time of 1000 hours
the display is automatically reset to
0.0 h.
19. Main menu Memo I
The main menu Memo is started by pressing this but-
ton:
I
This menu is used for managing model memories. It
contains the following functions:
x Setting up a new model (memory)
x Selecting, copying, erasing a model (memory)
x Unlocking and locking flight phases
x Interrogating and modifying the characteristics of
the model memory
x Modulation
Selects one of the two operating modes
FM/PPM or FM/M-PCM,
sets FAIL-SAFE in FM/M-PCM transmission mode:
¦Memory
¨Exit
Select model ....
Copy ....
Erase ....
Flight phase ....
Properties ....
ªNew model ....
Modulation ....
19.1. Selecting a model memory
In this menu you select the model memory, i.e. the
model you wish to work on.
In the main menu
Memory choose the Select model
point.
A list of all model memories is now displayed:
¦Select model
¨Exit
1 EasyStar
2 Twister x
3 Gemini
4 ---------
5 Cularis
ª6 FunJet red
Use the 3-D digi-adjuster to select the model which
you wish to fly (or set up).
Press the 3-D digi-adjuster or the ENTER button to
confirm your selection and execute the memory
switch.
Note: Throttle-Check when you change memories
(Î 14.1.2.)
If you have activated Throttle-Check (
Check Thr.) in
the menu
¡Setup, Transmitter:
Check Thr. ON
the software checks whether the throttle control is in
the Idle position when you switch to a different model
memory.
Current model
Selected target
Vacant memory