Operation Manual

ROYAL pro
58
REFERENCE Section
The REFERENCE SECTION is the part of the manual
where you can look up terms and find out detailed in-
formation about individual menus or parameters.
This section of the manual describes all the menus of
the ROYAL
pro . The sequence is the same as that of
the main menus when you access them directly using
the six dedicated buttons (Chapters 14. to 19.). The
description of the menus is also arranged in the order
in which they occur when you leaf through using the
3-D digi-adjusters.
All the menus are summarised in a clear manner on
the separate overview sheet supplied in the set, so
that you can quickly find functions which you do not
need to use regularly.
14. Main menu ¡Setup
The main menu Setup is opened by pressing this but-
ton:
¡Setup
¨Exit
Transmitter ....
Mixer def. ....
Assignment ....
Training ....
User ....
The settings in these menus are “global”, i.e. they ex-
tend beyond individual model memories, or apply to
the transmitter as a whole.
14.1. Menu Transmitter
¡Transmitter
¨Exit
Sound All
Safety
Check thr. ON
Check RF ON
Battery
ª Alarm 7.10V
Capacity 2100mAh
Charge 275mAh
SlfDsCharge low
Display
Contrast 0
Trim graph 0
Note:
If the screen area is not sufficient to display all the
sub-menus, this is indicated by means of arrows (
or ) at the left-hand edge of the screen. In this case
you can access the start or end of the list by scrolling
up or down using the UP / DOWN buttons ( / ) or
one of the two 3-D digi-adjusters.
14.1.1. Parameter Sound
The software allows you to select which events are to
be accompanied by an audible beep:
Values Meaning
Battery_
Battery alarm only
Bat+Trim
Battery alarm and trim increments
B+Tr+Tim
Battery alarm, trim increments and timers
Init off
All off, except power-on melody
All _
All audible signals
14.1.2. Parameter group Safety
Parameter: Check thr.
Function Warning if throttle is not at a safe setting (Idle or
(electric) motor OFF) when you switch the trans-
mitter on or change model memories
Values
ON OFF
Default
ON
Effect Affects current model only
Parameter: Check RF
Function RF channel is displayed at power-on, and must
be confirmed before an RF signal is transmitted.
Values
ON OFF
Default
ON
Effect Affects current model only
14.1.3. Parameter group Battery
Parameter: Alarm
Function Battery alarm threshold
Values
6.70V to 7.50V (increment 0.01V)
Default
7.0V
The threshold for the battery alarm can be adjusted to
suit your own preferences and the condition of the
transmitter battery.
 Tip: this setting affects the residual time, i.e. the
time between the alarm sounding and the transmitter
shutting down.
Switch the transmitter on with the aerial extended and
the RF module active (RF status LED must be flash-
ing). You do not need to operate the transmitter sticks.
Parameter: Capacity
Function Capacity of the rechargeable transmitter battery
for the purposes of battery management
Values
0mAh to 4000mAh (increment 50mAh)
Default
2100mAh
Î14.1.
Î14.2.
Î14.3.
Î14.4.
Î14.5.