Operation Manual

14. ERROR MESSAGES
Power Peak®
®
Quad EQ-BID is equipped with special safety features to ensure safe and
reliable charging and discharging operation. As soon as a fault occurs, a corresponding
message appears in the display and the piezo buzzer emits a shrill warning tone. After
eliminating the cause of the problem, the following error messages can be acknowledged/
erased by pressing the "ESC" button.
Operating Instructions
Power Peak
®
Twin EQ-BID
29
[ INPUT VOLTAGE ]
*The input voltage is 10.86 V
*Please check the Input vol-
tage!
[ NO BATTERY ]
*No Battery
is connected to the output.
[ REVERSE POLARITY ]
*The battery is connected
with reverse polarity to the
output!
[ BREAK ]
*The battery connection
is disconnected.
*Please connect the battery
and connect
[ SHORT CIRCUIT ]
The output
has a short circuit
*Please check the Output!
[ VOLTAGE TOO LOW ]
*Output voltage is
lower than the
selected cell count or Voltage
[ VOLTAGE TOO HIGH ]
*Output voltage is
higher than the
selected cell count or Voltage
[ TEMPERATURE SENSOR ]
*The Temperature sensor
is reverse polarity or defective.
[ BATTERY TEMP. TOO LOW ]
*The battery temperature
is for safe operation too low!
[ BATTERY TEMP. TOO HIGH
]
*The battery temperature
is for safe operation too high!
[ INTERNAL TEMPERATURE
]
*The internal temperature
is too high!
[ DATA COMMUNICATION ]
*Contact the
Multiplex Service department.
[ BID CHECK SUM ]
BID is defective,
press any button to initialise.
[ WRITE BID DATA ]
*The Data will
not be stored
in the BID system.
*If this message
is displayed continuously,
replace the
BID System.
[EQUALIZER VOLTAGE TOO
HIGH]
Equalizer voltage
is too high.
# 30 8563
63