Operation Manual

5.6 ENTER USER INFORMATION

Use the "MODE-/ESC" buttons to set-up the User

Settings in the main menu.

Activating the "TEMP MODE" line in this main menu, one

can set-up the desired temperature units. There is the

choice of

C and

F to select from.

The second line "BUTTON SOUND" can be pre-set,

whether every press of a button sounds or not. There are

two possibilities, the sound can be turned on- or off.

By activating the third line "FINISH SOUND", the time it

plays can be set. There are the following options:

Off - 5 secs. - 15 secs. - 1 Min. - On

In the "MELODY" line, one can select from 10 diffe-

rent melodies to play at the end of a charge procedure.

Following the selection of a new melody, this will be played

until the "ENTER" button has been pressed.

The table summarises all the of the Parameters that may be used.

Th t bl i ll th

Parameter Settings

Temperature units

F /

Button beep ON/OFF

Finish melody Off - 5 secs. - 15 secs. - 1 Min. - On

Melody Sounds 1 to 10

Operating Instructions

Power Peak

Twin EQ-BID

# 30 8563