Operation Manual

First connect the BID chip/key via the adapter lead

or directly to the charger. This now automatically

causes the screen display shown here to appear.

To set up the charging parameters, press the

ENTER button. Thereafter, the charging mode (char-

ge, discharge or ENTL-charge) can be adjusted with

"DEC" button. In case the battery type N/A is indica-

ted, please refer to chapter 11 „BATTERY ID INCOMPATIBILITY“. The further procedure

is identical to that used for a manual start. This procedure is described in Section 7.4.

Following a charge or discharge cycle, the most important data is stored on the chip/key.

10. END OF A CHARGE / DISCHARGE PROCESS

The charger automatically finishes a charging or discharging operation precisely at the

correct time. The processor takes into account the charging parameters. The optimum

process is used for each type of battery.

10.1 DISPLAY OF THE CHARGE / DISCHARGE DATA

During a charge or discharge process, the values for that process are constantly shown

in the working display (see Chapter 5.1).

An audible signal will be heard upon suc-

cessful conclusion of the charging process.

As shown in the illustration opposite, the

most important data are shown in the

display.

Operating instructions

POWER PEAK® TRIPLE 360 W EQ-BID

Status display

flashing ‘F’ (finish)

Battery type

Actual battery

voltage

Charge /

discharge

current

Elapsed char-

ge / discharge

time

Charged-in

or discharged

capacity

# 30 8562