Operation Manual

SETTING THE DISCHARGE CURRENT

The discharge current up to 1A can be selected in

steps of 0.1 A. The maximum discharge current is

dependent on the battery voltage as well as the bat-

tery type. The processor in the battery charger limits the maximum discharging current.

SETTING THE AUDIBLE SIGNAL

In this menu, the end of charge process warning sound can be selected. There are 5 sound

styles to choose from, in addition, the sound gene-

rator can also be turned off. Each pressing of the

"INC" or "DEC" button will set a new sound and at

the same time to make the choice easier, will sound

again.

SAVING THE SETTINGS

Press the ‘INC/ DEC ’ button to leaf through the screen display until the arrow is next to

End. The settings are saved by pressing the ENTER

button. The Display shows the start display again, it

returns to its initial home position.

7.4 STARTING A CHARGE/DISCHARGE OR STORE PROCESS

t1SFTTA."/BOEUIF4UBSUEJTQMBZBQQFBST

t1SFTTA&/5&3UPQSFQBSFUIFEJTQMBZFE

memory for the charge process.

t6TFUIFA.0%&CVUUPOUPTFMFDU

the desired process

t5PNBLFTVSFUIFTUPSFEQBSBNFUFSTBSF

displayed once again

t1SFTTUIF45"35CVUUPOUPTUBSUUIFDIBSHJOH

process, an acoustic signal indicates the

status. Then the working display,

containing all the important parameters,

is then shown (see Section 5.1).

8JUIUIFh*/$hPSh%&$hCVUUPOZPVDBODIBOHF

the current during the charging procedure,

the new value flashes before being adopted.

Operating instructions

POWER PEAK® TRIPLE 360 W EQ-BID

# 30 8562