Operation Manual

Alternatively, the battery voltage can be selected in

2V-steps per cell for lead battery packs.

The following voltages are available to use for lithium batteries:

ENTERING THE BATTERY CAPACITY

In this menu, battery capacity can be selected in

steps of 100 mAh (PB, 500 mAh). The battery capa-

city setting for lithium battery packs mainly serves

as the basis for the 1C charge, i.e. the charging current is automatically set to the corres-

ponding 1C charge of the battery. It additionally serves as a battery safety function.

The range of capacities shown in the

table here are available and depend

upon the type of battery:

SETTING THE CHARGING CURRENT

The charging current up to 10A can be selected in

steps of 0.1 A. The maximum charging current is

dependent on the number of cells or the battery vol-

tage and the maximum charging capacity (max. 2C

for lithium batteries). The processor in the battery

charger limits the maximum charging current if the maximum charging capacity is excee-

ded.

Operating instructions

POWER PEAK® TRIPLE 360 W EQ-BID

Cell count Battery voltage

1 2 Volt

2 4 Volt

3 6 Volt

4 8 Volt

5 10 Volt

6 12 Volt

Battery type Battery capacity

NiCd 100 - 9900 mAh

NiMH 100 - 9900 mAh

LiPo 100 - 9900 mAh

LiIo 100 - 9900 mAh

LiFe 100 - 9900 mAh

Pb (lead) 0.50 Ah - 20.00 Ah

# 30 8562