Operation Manual

5. USING THE CHARGER FOR THE FIRST TIME
Power up the charger using a direct current of 11 to 15 V. You can also connect the char-
ger to a 12 V lead-acid battery or to the 230 V mains switched power supply unit, No. 8539.
Ensure correct polarity when connecting (red = positive/black = negative).
5IFMBOHVBHFTFMFDUJPONFOVBQQFBSTJGUIFhhCVU-
ton is pressed and held while connecting the supply
voltage. This can be
If the INC button is pressed after the connection
to the power supply and the "Cap touch sensor
" (blue LEDs light above the menu buttons) is
held down during the initialisation
, the language selection menu will appear.
The menu language can then be selected from this display. The available languages can
CFTFMFDUFEPOFBGUFSUIFPUIFSXJUIUIFh*/$hPSh%&$hCVUUPOT*OEPJOHTPUIFSFBSFUIF
following options available:
t (FSNBO
t 'SFODI
t *UBMJBO
t 4QBOJTI
t &OHMJTI
Language selection must be concluded by pressing the ENTER button. The start display
shown above will then appear.
5.1 WORKING DISPLAY
This display provides the user with all the necessary information during a charging or
discharging operation. The upper line of the status display shows the type of operation
(C for charging, D for discharging, F for finish and alternately C/B for balancing lithium
batteries). The charged or discharged capacity and the time elapsed since the start are
also shown on the top line. The type of
battery (NC for nickel-cadmium battery,
NM for nickel-metal battery, LP for lithium-
polymer battery, Li for lithium-ion battery,
LF for lithium-ferum battery and Pb for
lead battery) is shown on the bottom line.
The display therefore shows all important
parameters at a glance during a charging
or discharging operation.
Operating instructions
POWER PEAK® TRIPLE 360 W EQ-BID
8
Status display
Battery type
Actual battery
voltage
Charge /
discharge
current
Elapsed
time
Capacity display
# 30 8562
32