Operation Manual

First connect the BID chip / KEY to the charger

using the adaptor lead. This automatically causes

the screen display shown here to appear.

If the charging parameters on the chip are OK,

press the ENTER button to prepare the charging/

discharging process. The further procedure is iden-

tical to that used for a manual start. This procedure

is described in Section 7.4.

While charging or discharging, the most important data is stored on the chip/key.

10. END OF A CHARGE / DISCHARGE PROCESS

The charger automatically finishes a charging or discharging operation precisely at the

correct time. The processor takes into account the charging parameters. The optimum

process is used for each type of battery.

10.1 DISPLAY OF THE CHARGE / DISCHARGE DATA

During a charge or discharge process, the values for that process are constantly shown

in the working display (see Chapter 5.1).

An audible signal will be heard upon

successful conclusion of the charging pro-

cess. As shown in the illustration opposi-

te, the most important data are shown in

the display.

Operating Instructions

Power Peak® Quad EQ-BID 230 V

Status indicator

Flashing ‘F’

(Finish)

Battery

type

Current battery

voltage

Charge or

discharge

current

Charge/dis-

charge time

Charged or

discharged

capacity

# 30 8196