Operation Manual

47
12.3. Using the diagnosis lead
If you just want to check and adjust your model without flying it, you can connect
the transmitter directly to the receiving system by means of a diagnosis lead, with-
out the transmitter radiating an RF signal.
This is the procedure:
1. Connect the transmitter (multi-function socket) to the receiving system in the
model using the diagnosis lead
2. Switch on the transmitter first (the RF section stays switched off)
3. Switch on the receiving system
Two diagnosis leads are available, depending on the receiving system in your
model:
Diagnosis lead for MULTIPLEX switch harness with charge socket # 8 5105
Diagnosis lead for „EinStein“ # 8 5162
12.4. Care of the transmitter
Protect your transmitter from mechanical damage, temperatures above 60°C (direct
sunshine inside a car), damp, solvents, fuel, combustion residues and dust (e.g. in
the modelling workshop). Bear in mind also that if the temperature alters quickly
(e.g. when you move from a warm workshop to a cold car) condensation may ap-
pear on the transmitter, and the moisture could prevent it working properly. If you
think this might have happened, carry out the range check with particular care, and
allow the transmitter plenty of time for its temperature to adjust to the ambient
conditions. Check also that the transmitter is completely dry on the inside.
Cleaning the transmitter
The best way to remove dust is with a soft paintbrush. The case can be cleaned with
a slightly damp cloth and a mild household cleaning agent.
!!
Ensure that no fluid gets inside the transmitter.
Maintenance
Your transmitter contains no parts which require maintenance.
!!
However, we strongly recommend that you carry out a range check and test all
the functions at regular intervals.
12.5. What should I do if I have queries or problems?
The first step should always be to ask your local model shop for advice.
Our Service Centres are listed on the back cover of these instructions.
For technical questions or queries about the use of the transmitter the
MULTIPLEX hotline is available on 0049-7233-7343
You can also reach us by eMail on the following address:
„[e-mail]“