Operation Manual

29
This is how you activate the V-tail mixer:
Procedure
Display
GB: D:
1.
Select the V-MIX setting in the MIX menu and
switch to the second line
V-MIX VMIX
OFF AUS
2.
Activate the V-tail mixer
V-MIX V-MIX
ON AN
3.
Return to the first line
Continue as shown in the flow chart
This is how you adjust the V-MIX mixer:
1. Activate V-MIX (see step 2. above)
2. In the SERVO menu set the correct
direction of travel for rudder only as
shown (see 8.3.1. Selecting the direction
of rotation and servo signal format).
3. If you find that elevator is now reversed,
select „ON-“ in the V-MIX menu point.
4. Adjust the mixer inputs for elevator and rudder using Dual Rates
(see 8.2.4. Dual Rates).
Note:
When setting the servo end-points ensure that the travel of both control surfaces is
identical (see 8.3.2. Adjusting the servo centre and end-points).
8.5.3. DELTA mixer for flying wings and deltas
This mixer is designed for deltas and flying wing model aircraft which are controlled
by two wing-mounted control surfaces which provide superimposed elevator and
aileron control. In model flying circles this type of control surface is known as an
elevon. The word elevon is a combination of elevator and aileron. The DELTA mixer
eliminates the need for a mechanical mixer.
Preparation:
• Connect the two elevon servos to channels 1 and 5
Option
GB: D:
Effect
OFF AUS
DELTA mixer disabled
ON AM
DELTA mixer active
ON- AN-
DELTA mixer active, ELEVATOR input reversed