Operation Manual

8. Setting up a new model

8.1. Preparing the model and receiving system

8.1.1. Preparing the model

For setting up a new model you will need the completely built model, set up cor-

rectly, ready to use. Thus the first step in preparation is to install the receiving sys-

tem and the other essential components in your completely finished model.

Please read Chapter 12. „The system in use“.

8.1.2. Connecting the servos to the receiver

The servos must be connected to the receiver in the appropriate sequence, depend-

ing on the type of model you have built:

Model type Universal (UNI, U) Heli (Heli, H)

Receiver

output

Servo

with

DIFF-mix

with

V-tail-mix

with

DELTA-mix

Servo

1 Ailerons Aileron 1 Elevon 1 Roll axis

2 Elevator V-tail Pitch axis

3 Rudder V-tail Tail rot. (yaw)

4 Throttle Collect. Pitch

5 Control (E) Aileron 2 Elevon 2 Throttle

6 Contr. (F) / Spoiler Control (E)

7 Control (G) Control (G)

Note:

Controls (E), (F) and (G) are optional, and may be controlled by switches, rotary

knobs or sliders which are not fitted as standard. See 4.1.5. COCKPIT

expansion

facilities.

8.2. Preparing the model memory

The procedure described in the next section must be carried out before you do any

programming relating to the new model. The first step is to switch to a vacant

memory spot, or one which you no longer need (see 6.1. Switching model memo-

ries).

8.2.1. Selecting the model type / Erasing the model memory

Here the model type can be selected to enable access to the corresponding mixers:

Model type for:

-- leave the present type unchanged

U (Universal = UNI) Aircraft, vehicles, boats

H (Helicopter = HELI) Helicopters