Integration Instructions

ManualsBrandsMultiplex Modellsport ManualsElectronics2.4GHZ module for remote control

Project name:

Trinity

Module No.:

1-00391 WSRX M-Link 2.4GHz

Installation Information

The modular transceiver WSRX 2.4GHz is only approved for use by the grantee in its

own products and not intended for sale to third parties.

WSRX 2.4GHz meets the integration instructions regarding FCC 15.212

The whole Trinity assembly instructions are described in the TRINITY installation

manual.

Contained FCC ID: 2APABWSRX

Technical Documentation

Summary of content (8 pages)

PAGE 1
Technical Documentation Project name: Trinity Module No.: 1-00391 WSRX M-Link 2.4GHz Installation Information The modular transceiver WSRX 2.4GHz is only approved for use by the grantee in its own products and not intended for sale to third parties. WSRX 2.4GHz meets the integration instructions regarding FCC 15.212 The whole Trinity assembly instructions are described in the TRINITY installation manual.
PAGE 2
Overview TRINITY Communication Link The communication with the UAV Trinity is ensured by two links: 1. QBase, a 915MHz flight data link. A downlink sends telemetry data from the Trinity to QBase ground control and an uplink sends commands to the Trinity Qbase air control. 2. The second link is a 2.4 GHz RC link between the RC-radio Cockpit SX and the Trinity. It is used as an uplink for control commands and as a downlink sending telemetry data from the Trinity to the RC-radio.
PAGE 3
PAGE 4
Technical Documentation Antenna description The RF-module WSRX is a true diversitiy transceiver. The maximum output power is 20dBm EIRP. Its two lambda/4 internal wire antennas are fixed to the PCB board with a unique connector. Mounting the module refer to page 7+8 in this document.
PAGE 5
Excerpt from Trinity Assembly Specification V2 1-01256 TRINITY F9+ Assembly Specification V2 Part A – Part lists and definitions Release date: 2019-08-20
PAGE 6
1-01256 TRINITY F9+ Assembly Specification V2 1 General references  This document may not be handed on to any third party without the explicit clearance from MULTIPLEX.  This specification is written and designated for skilled users with substantial technical capabilities.  Indications of horizontal, vertical or longitudinal position are always meant in the direction of flight at normal attitude.  Item descriptions in the text are written in bold italic letters.
PAGE 7
1-01256 TRINITY F9+ Assembly Specification V2 9.2.4 1. 2. Installing Receiver and Magnetometer Part # Item number Description German Description English Quantity 1 1-00391 Platine Empfänger Telemetrie_Trinity Receiver Telemetry Board 1 2 1-01157 Magnetometer Magnetometer 1 Install the Receiver Telemetry Board (#1) at the innermost position of the designated cavity with hot melt adhesive (see red arrow). Lay the antennas in the slot and the Antenna Tube 60mm.
PAGE 8
9.2.