Installation Instructions

Trinity user manual |
15
7.2.2 Left section
Message Window
Shows info (blue), warning (yellow) and error (red) messages.
Map Settings
Adjust the display settings of the map.
Zoom In Zoom Out
?
Pan to …
Select if you wish to pan to the UAV, to the mission or
if you wish to search for an address.
Select Map
7KHOLVWLQFOXGHVRQOLQHDQGRIŴLQHPDSV7RXVHRQOLQHPDSV
make sure QBase is connected to the internet.
Wind Settings
4%DVHGHWHUPLQHVWKHŴLJKWWUDFNXQGHUFRQVLGHUDWLRQRIWKHZLQGLQŴXHQFH6HHFKDSWHUIRUIXUWKHUGHWDLOV
20 km
Zoom in to select the Scale and select New Measurement to measure a distance between two locations.
The button becomes visible when zoomed in. Select the
Scale again to close the measurement tool.
7.2.3 Right section
The right section of QBase includes the relevant buttons for planning and monitoring a mission (see chapter 7.3 & 7.6).
Monitoring UAV
Monitor the UAV during the mission accomplishment.
Mission Template
'HƓQHWKHJHQHUDOPLVVLRQVHWWLQJV
Flight Planning
'HƓQHWKHWDNHRIIDQGODQGLQJSRVLWLRQDQGDGMXVWWKH
waypoints.
Area Planning
'HƓQHWKHŴLJKWDUHD
Read / Write Flight Plan
8SORDGWKHŴLJKWSODQWRWKH7ULQLW\VHHFKDSWHU
7.2.4 Footer
UAV Command
UAV Command
Enables the user to control the Trinity via QBase (see chapter 7.6.2)
Payload Info
Payload Info
Information about the current state of the payload (see chapter 7.6.3.)
$OWLWXGH3URƓOH
$OWLWXGH3URƓOH
7KHDOWLWXGHSURƓOHRIWKHFXUUHQWŴLJKWWUDFNFDQEHGLVSOD\HGLQWKHERWWRPFHQWHU
$OWLWXGH3URƓOH1DYLJDWLRQ
•
By clicking left on the $OWLWXGH3URƓOHWKHDOWLWXGHDQGWKHŴLJKWGLVWDQFHLVGLVSOD\HG
• The waypoints of the mission are numbered and shown in purple.
• The current waypoint is framed.
•0RYHWKHSURƓOHZLWKWKHULJKWPRXVHNH\
• Zoom in and out with the mouse wheel.
• Use AutoscaleWRGLVSOD\WKHFRPSOHWHSURƓOH
Mission Info
Mission Info
Gives an overview of the planned mission (see chapter 7.3 step 51).
7 QBase – ground control station