Cut Sheet

ManualsBrandsMultiple Manuals& CordSER Service Entrance Cable, 4/0-4, Aluminum, 500'

4/0-4/0-4/0 18 18 878 X 1462 150 180 205 205 765 CL

4/0-4/0-2/0 18 18 835 X 1419 150 180 205 205 691 CL

Table values reflect XHHW-2 conductors.

+Allowable Ampacities:

Allowable ampacities shown are for general use as specified by the National Electrical Code, 2008 Edition, Section 310.15.

60° C - When terminated to equipment for circuits rated 100 amperes or less or marked for 14 through 1 AWG conductors. See NEC

Article 338.10(B)(4).

75° C - When terminated to equipment for circuits rated over 100 amperes or marked for conductors larger than 1 AWG. May not apply,

see NEC Article 338.10(B)(4).

90° C - Wet or dry locations. For ampacity derating purposes.

Dwelling - For units, conductors shall be permitted at listed ampacities as 120/240-volt, 3-wire, single-phase services and feeders per

NEC Article 310.15.

*For compact-stranded construction, the number of wires, as permitted by UL Standard 83, UL Standard 854, and ASTM B-801, may be

reduced as follows:

19-Wire Constructions - 18 Wires Minimum

STANDARD PACKAGE

CODE:

B - 1000' Reel

C - 500' Reel

RECOMMENDED SAMPLE SPECIFICATIONS:

SER Sample Specification: Cable shall be UL-listed Type SE, Style SER, suitable for operation at 600 volts or less as specified in the National Electrical Code.

Conductors shall be AlumaFlex TM aluminum alloy, weather resistant PVC jacketed, as manufactured by Southwire Company or approved equal.

SEU Sample Specification: Cable shall be UL-listed Type SE, Style SEU, suitable for operation at 600 volts or less as specified in the National Electrical Code.

Conductors shall be AlumaFlex TM aluminum alloy, weather resistant PVC jacketed, as manufactured by Southwire Company or approved equal.

AL SE, SER, and SEU

Fri Jul 16 11:53:55 EDT 2010 Page 3 of 3