Specifications

To cut the steel sheets of thickness up to 1 mm (0.04 inches), it is sufficient to set MODE I to position 1-4 and set voltage to 190-

210V. Steel sheets of higher thickness may be cut using MODE I and setting the current indicator to position 6 and setting the

voltage display to 210 -230 V.

Thicker sheets should be cut using MODE II. Set the MODE I current indicator to position 6 and voltage to 210-220 V. Then

activate MODE II.

Direct arc of MODE II appears automatically as the torch nozzle is brought 2-3 mm (0.08-0.12 inches) from the surface of the

workpiece.

Select rate of torch translation along cut such that the arc stays on the workpiece material and molten metal is removed. If torch

translation rate is too high, metal will not be cut, and if translation rate is too low or zero, direct arc may break because there is no

metal in the cut.