Specifications
4.9 After operation
-.
-.
.
Press ”OFF” button on
Be sure ”OFF” LED is illuminated
- power supply power cable from wall receptacle
power supply
Disconnect
Disconnect MODE II wire with clamp from power supply
- Disconnect torch cable from power supply output connector
-.
It is prohibited:
to disconnect the torch cable connector with torch operational and/or "ОN” LED
illuminated This results in connector burnout
-
..
4.8.2
.
.
Automatic Filling
Dip nozzle in 3-5 cm (1-2 inches) of water free of
sediment for
-
- 4.7.
-(
) 2 - 3 (see igure)
.
Shut torch down per Section
minutes f This
method can only be used immediately following
torch shutdown because of the suction effect
Once filled, wipe torch dry
4. Refilling
- Fill the torch as written in Section 4.4
8 Torch
Torch may be refilled in two ways
refilling4.8.1 Forced
5.7
(
5.6.1)
( 8).
8T
Soldering, Brazing, and Braze Welding Procedures
Soldering, brazing, and braze welding are normally performed using MODE I see
Section .
More detail on soldering, brazing, and braze welding of various materials is given in the
Process Attachment section Secton
5. orch Shutdown
- Press
-
- If torch would fill with water, then evaporate it
(see “Caution!” note at the bottom of page 25)
- Make certain that “OFF” LED on power supply is
illuminated.
Cool torch down by dipping nozzle in cm
(1-2 inches) of WATER for several seconds
until sizzling sound stops but no longer
Otherwise, torch will automatically fill with
water rather than water/ethanol mixture and
most welding processes will become
unavailable
3-5
.
,
.
”OFF” button on power supply (see
Figure).
Caution
Shut down and cool torch if nozzle turns red or jet turns green for a long time
Sections 1 2
!
- (see
7.1 , 7.1 ).
Caution!
If you want to shut torch off in case of emergency,
press and hold start button 6-8 seconds.
5
22
4
27
Caution!
- Do not allow unprotected areas of your body to come into contact with hot torch
surfaces.
- When operating in MODE II do not allow conductive items to come into contact with
nozzle or cap unless secured in filler holder.
- Do not remove filling neck cap while torch is operational.
It is prohibited:
- to disconnect the torch cable connector with torch operational and/or "ОN” LED
illuminated This results in connector burnout.