Specifications

The power supply comprises:
Fuse
Ground Connector
Power Cable
Fan Screen
Voltage Display
MODE I Current
Indicator
MODE II Current
Indicator
Current Control Panel
“ON”
()Button green
“OFF”
()Button red
“OVERHEAT”
()Thermal Protection LED red
Safe Voltage LED
SELV(“ ”) ( )green
Vents
Power Cable Output
Connector
Protective
Housing
Positive Output
8 Stainless steel not welding
Use an ethyl alcohol concentration of to and appropriate filler wire
Process Attachment For thickness of under . mm (0,1 inch) use brazing brass or
silver-based solder
9. Process fluid leak from under the cap
Cap not tight enough - tighten cap
10 Process fluid leak from under the torch filler neck cap
Filler neck cap not tight enough - ighten cap.
1 Plasma jet is green in color
Burnout of central hafnium insert at cathode tip crater depth exceeds 0.3 mm, i.e.
0,01 inch .
File cathode down until crater disappears Section
B Cathode and nozzle misaligned
Remove cathode assembly from torch and align Section
2 Nozzle turns red during operation
Nozzle contaminated
Clean nozzle with drill bit see "What's included"
B Cap loose
Tighten cap using greater torque
C Presence of a foreign particle such as a sand grain between nozzle and evaporator
Clean contacting surfaces of nozzle and evaporator
D Nicks on contacting surfaces of nozzle and evaporator
Grind contact surfaces with fine sand paper on a smooth surface
E Spring not installed on evaporator
Remove evaporator and install spring Section .6 item 6
3
Perform torch maintenance Section
4 Service life of consumables Where can consumables be purchased
Cathode and nozzle life is 1 2 hours depends on operating mode and timely
maintenance
All consumables are available from an authorized dealer
5 Voltage indicator shows messages not described in manual
If ”ON” button is depressed repeatedly, the indicator will display digital engineering data
describing power supply status. These data have no impact on power supply operation
This is indicated by a decimal point found in the digital data
If this should be the case, continue pressing the ”ON” button of the front panel of the
power supply until there are no points on the display
7. .
55% 60% (see
). 25 (
).
7.
.
7. .
t
7.1 . .
А) (
)
* ( 6.4).
).
* ( 6.4).
7.1 . .
А) .
*().
).
.
) .
*.
).
*.
).
*(6).
7.1 . Difficulty starting torch
( 6).
7.1 . ? ?
0- 0 (
).
.
7.1 . .
.
.
.
*.Turn torch off first
7
3
33
16
Caution!
Attachment or replacement of a plug should be made only by authorized personnel
observing the following requirements:
- The plug and the socket should be rated for a working current not less than 20A for
standard voltages of 100, 110, 120 V and 16A for standard voltages of 208, 220, 230, 240 V.
- When connecting wire, observe the following conformity between contacts of the plug and
cable wires:
- Black (brown) for phase contact
- White (blue or dark blue) for neutral contact
- Yellow (green or yellow-green) for ground contact