Instructions / Assembly

BOAT & PWC ROLLER RAMP ASSEMBLY
Keel roller
LUMBER & HARDWARE :
MATERIAL NEEDED
MULTINAUTIC’S PARTS TO COMPLETE PROJECT AS SHOWN :
3x 19102 inside corners kits
1x 19111 leg holders kit
4x 10200 8 galvanized steel bolts & nuts kits
1x 34106 keel roller
1x 34110 or 4x 34111 wheel kits
1x 34200 or 1x 34202 winch
1x 34300 winch strap
1x 11005 post (cut in 2 pieces)
2x 15005 or 1x 15025 (2/pack) pile caps
2x 11108 base plates
2x 2” x 8” x 16' (sides)
1x 2” x 6” x 14' ou 16' (end pieces & struts)
1x 2” x 4” x 10' (winch pole and diag. support)
More or less 30 wood screws
Bolts for Keel Roller
Bolts for Winch
STEP-BY-STEP GUIDE
1) Cut lumber to sizes according to plan.
2) Pre-assemble with a couple screws making sure you’re not putting the
screws where you will drill the holes for steel hardware.
3) Mark holes with a pen by positioning brackets and marking inside the holes.
4) Drill holes and bolt on hardware.
5) Install wheels, keel roller and winch post.
Item #
°
°
2” x 6” x 72”
2” x 6” x 21”
2” x 8” x 192” (16’)
or as needed
(we recommand galvanized steel bolts
& nuts or lag bolts)
2” x 4“ x 32-½”
2” x 4“ x 29-¼
”
(2x)
°
°
°
Saw
Measuring tape
Star screwdriver
Drill with 7/16’’ drill bit
3/8” and 3/4” wrenches
TOOLS :