Instructions / Assembly

ManualsBrandsMultinautic ManualsBuilding materialsBoat Ramp Kit

Multi

NAUTIC

This set of wheels is one of the components to build a

mooring ramp for small boats of up to 1200 lbs.

This leaﬂet will guide you through the steps to complete your project.

If this box is not part of a complete ramp kit, here are the products to

purchase. Look inside this Assembly Guide for the required lumber, screws

and bolts listing. Note that some ramp kits include the screws.

BOAT RAMP

ASSEMBLY

GUIDE

(using wheel kit

34110)

Help line :

1-800-585-1237

info@multinautic.com

Winch

Strap

Back

Plate

Inside

Corner

Leg

Holder

Kell

Roller

Winch

Bumper

# 10002 10003 10011 34202 34300 34106 Choices

3 ft.

Post

11007

Base

Plate

11107

Post Cap

BL or WH

15055 or

15025

6 x 18 x 2 x 1 x 1 x 1 x +/- 24" 2 x 2 x 1 pair

Summary of content (4 pages)

PAGE 1
Multi ® NAUTIC BOAT RAMP ASSEMBLY GUIDE This set of wheels is one of the components to build a mooring ramp for small boats of up to 1200 lbs. This leaﬂet will guide you through the steps to complete your project. If this box is not part of a complete ramp kit, here are the products to purchase. Look inside this Assembly Guide for the required lumber, screws and bolts listing. Note that some ramp kits include the screws.
PAGE 2
HARDWARE TOOLS : Inside Corners 6x Back Plates 18 x Leg Holder 2x Winch 1x Winch Strap 1x Kell Roller 1x Bumper 24" Pen Drill 7/16” drill bit Hammer 3/4” wrench Tape measure Screwdriver Qty Size Length 36 3/8" 2 ½" Carriage bolts w/ nuts, lock & ﬂat washers* 2 3/8" 4 ½" S.s.
PAGE 3
STRUCTURE Qty TOOLS for the structure: 2’’ x 8’’ x 16’ 2x 2’’ x 6’’ x 8’ 2x 2’’ x 4’’ x 10’ 1x Miter saw or saw Level Tape measure Square bit screwdriver Side beams 2 End beam (for leg holders)* 1 Cross members* 5 or 6 Winch post 2 Diagonal winch post brace** 1 Post brace strengthener 2 ± 50 Wood screws*** We recommend to be 2 people to assemble and install this mooring ramp. The time required is estimated at 4 hrs.
PAGE 4
WHEELS & INSTALLATION TOOLS : Tape measure Pen Drill with 7/16” drill bit 9/16” & 3/4” Wrenches Wheels 2x Posts 2x Base Plates 2x PVC Caps 2x 1 1- Assemble the Wheels as shown above with the nylon bushing, the stainless steel center axle bolt and the 2 triangular plates. 2- Mark the side beams at the distances shown in Figure C with lines 2" from the top of the beams. It is on these lines that the triangular plates will line up to mark the mounting holes.