User guide

M349 Announcer version 01.02 revised 4 August 2005 page 3
1. This equipment has been approved pursuant to Council Decision 98/482/EC [CTR 21]
for pan-European single terminal connection to the Public Switched Telephone Network
(PSTN). However, due to differences between the individual PSTN provided in different
countries, the approval does not, of itself, give an unconditional assurance of successful
operation on every PSTN termination point. In the event of problems, you should contact
your equipment supplier in the first instance.
2. The Multimessage Systems model 349 announcer is suitable for connection to
Exchange lines which provide Multi-Frequency (MF) signalling.
The model 349
announcer
is not suitable for connection as an extension to a payphone, neither
to a shared-service (party) line or a 1+1 carrier system.
3. lnterconnection directly, or by way of other apparatus, of ports marked in accordance
with BS 6301 or EN41003 with ports not so marked may produce hazardous conditions
on the telephone network and that advice should be sought from a competent engineer
before such a connection is made.
4. Interconnection circuits made to the audio in, out and out(8Ω) ports should be such that
the equipment continues to comply with the requirements of EN60950 2.3 for SELV
circuits. (the voltages in a SELV circuit shall not exceed 42.4V peak or 60V dc).
Advice should be sought from a competent engineer before such a connection is made.
5. The system is not suitable for use as an extension to a payphone.
6. Refer all servicing to qualified personnel or to the Multimessage Systems Customer
Servicing Department at the address given on the front page of this handbook. The
system does not contain any user serviceable parts.
7. The line cords and mains cable must be disconnected before removing the cover
of the announcer system.
TECHNICAL NOTES
Exchange Lines
MF REN of 3 (TNV3 CIRCUIT)
External input
-10 dBm 600 Ohms peak maximum input.
External outputs
0 dbm 8 Ohms
-10 dbm 600 Ohms
Dimensions
255mm long x 320mm wide x 40mm deep
Weight
3.2kg
Power Supply
230V AC 50 Hz
Power Consumption
65mA
Temperature
0 to 40°C working
-20 to +70°C storage
Relative Humidity
0 to 95% (non-condensing)