User guide

M349 Announcer version 01.02 revised 4 August 2005 page 22
Reset all ports
Only use this if you are experiencing problems.
Calls in progress will be cut off. The stored announcement data will be
tested and cleared if found to be incorrect. Make a note of your current
settings before you follow this procedure.
Lift handset press # # . From this 2
nd
menu press 7 (hidden key)
1-Delays 2-Enable
3-Guard 4-Reset #→
4 for Reset.
1-Reset All
2-Port type *→
1 for Reset All.
After a few seconds it returns to the
1
st
menu.
Press 1-Record
2-Play/Assign #→
Reset a port and set its type of clearing signal
Only use this if you are experiencing problems.
A call in progress will be cut off. The stored announcement data will
remain unchanged. Only change the type to ‘analogue’ if callers are
prematurely disconnected while listening to announcements with tones or
music, otherwise you could experience false calls, where callers hang up
during the greeting and the disconnect clear signal from the PSTN is not
presented.
Lift handset press # # . From this 2
nd
menu press 7 (hidden key)
1-Delays 2-Enable
3-Guard 4-Reset #→
4 for Reset.
1-Reset All
2-Port type *→
2 for Port type.
Port 0 not used
1..05 *→
Port 1 DTone
1..05 #-Change *→
1-Analog
3-Analog+DTone *→
Reset completed for
port 01 #→
1 to reset to analogue port type.
3 to reset to analogue + dial tone
clearing port type.
# for next port
1..5 enter port number
# to change port type