User guide

M349 Announcer version 01.02 revised 4 August 2005 page 12
Remotely Rerecord
The following assumes that the Announcement number you wish to rerecord is
the same as currently assigned to the port you are using for remote con-
trol. If the number is different then go to Remote Assignment of Announce-
ment to ports first.
Press # X X X X (your remote access key code)
After gaining remote access you will hear ‘pip pip’, press 1 #
to start recording, speak after the tone, press
# to stop. The recording
that you have just made is played back to you for confirmation.
Press # to accept the new recording, any other key will discard the new
recording. (Callers will continue to hear the old one.)
Press * you will hear the‘pip pip’ tone confirming that you are back at
the main menu again.
Press * again and the message that is assigned to the port you are calling
on will be played and remote control will end.
Remote Assignment of Announcement to ports
Press # X X X X (your remote access key code)
After gaining remote access you will hear ‘pip pip’
Press 2 The first announcement starts to play
Press 0 to play the next, or enter the announcement number 1..9 9 press #
to start.
When you hear the one to be assigned:
Press # then 1..5 for the first port in the range, then # to accept.
Enter 1..5 for the last port in the range, then # to accept.
You will hear the ‘pip pip’ tone confirming that you are back at the main
menu again.
Press * again and the message that is assigned to the port you are calling
on will be played and remote control will end.